Locking console insert

muddy12 · Jul 17, 2017

With my winch install almost finished, I decided to start working on a lockable insert for my console.
This is just a prototype so I can work out all the little details.
I'm just not sure if I want to stick with the "hinged door" design, or just make a kind of "false bottom" that locks into place.
Solid plate,

Or, hinged lid,

Sent from my iPhone using Tapatalk

EagleChief · Jul 18, 2017

That's cool!! I'm not sure which version I would go with, either. Almost leaning toward the hinged door. I know there are "safes" available for our trucks, already, but they want $200-$250 for the one I looked at. Probably not a bad price for a little security, but more than what I'm willing to spend.

Curlyp · Jul 18, 2017

Very cool! Great job! [emoji106]

Sent from my iPhone using Tapatalk

muddy12 · Jul 18, 2017

Yes, the price was my problem with the pre-made ones as well. Especially considering that I have an abundance of 16 gauge steel (that's what most of the available ones are made of), and the ability to make my own.

As I mentioned above, this one is just a prototype. Once I finalize the design, I'll use this one as a pattern for the final one, which will be made from steel, and without rivets.

Sent from my iPhone using Tapatalk

transam210 · Jul 19, 2017

I have the gun safe that replaces one of the coolers in the back floor. They're pretty cool

Sent from my iPhone using Tapatalk

jimmerz · Jul 19, 2017

transam210 said:
I have the gun safe that replaces one of the coolers in the back floor. They're pretty cool

Sent from my iPhone using Tapatalk

Where did you get it? Link? Thanks...

Sent from my XT1585 using Tapatalk

muddy12 · Jul 24, 2017

Need to pul it out for paint, but I got version 1.2 built using 16gage.
Overall, the fit and function is good, but I need to build a press brake. The sheet metal brake that I have just wasn't working for the internal bends. I had to go old school with a hammer and anvil.
Also, a single layer of 16g was a little flimsy for the lid, so I spot welded some reinforcement pieces to the under side.

However, the way I made this, it's just secured to the inside of the factory plastic console with 4 screws. It's not as secure as a full "safe", but I figure it's slightly better than a factory locking glove box, and way better than nothing at all.

Sent from my iPhone using Tapatalk

corneileous · Jul 24, 2017

That's pretty cool.

transam210 · Jul 24, 2017

jimmerz said:
Where did you get it? Link? Thanks...

Sent from my XT1585 using Tapatalk

http://www.gunsafes.com/Lock-er-Down-SUVault-2009-to-2017-Dodge-Ram-1500-Model-LD3029.html

Sent from my iPhone using Tapatalk

Locking console insert

muddy12

Senior Member

EagleChief

Senior Member

Curlyp

Senior Member

muddy12

Senior Member

transam210

Member

jimmerz

Junior Member

muddy12

Senior Member

corneileous

Senior Member

transam210

Member

Similar threads

Latest posts

Staff online

Members online

Forum statistics

Share this page