Elfster55
Member
Wondering if I can replace the stock gauges in the cluster with actual oil pressure and temp rather than the stock ones?
Gauges ?
- Thread starter Elfster55
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
charonblk07
Senior Member
- Joined
- Mar 14, 2013
- Posts
- 4,056
- Reaction score
- 2,072
- Location
- Calgary, Ab
- Ram Year
- 2009
- Engine
- F1-A forged 349ci
That's a negative. It's one big circuit board back there and the entire module is about 1 1/2" thick, so no room to even squeeze one in between.
OP
OP
Elfster55
Member
So I would have to run new gauges in the cubby he like I have seen and disconnect the other 2 right ?
charonblk07
Senior Member
- Joined
- Mar 14, 2013
- Posts
- 4,056
- Reaction score
- 2,072
- Location
- Calgary, Ab
- Ram Year
- 2009
- Engine
- F1-A forged 349ci
Aside from pulling the needles off you can't get rid of them from the cluster, but you can install your own gauges, either in a pillar pod, steering colum pod, a mirror pod, or something in the dash. You have to leave the stock system intact so it can feed into to the PCM.
Similar threads
Members online
- HarryS
- Black-Wolf
- hern50
- sr71
- MEGAVITES
- BlackSheepRebel
- mrmetalweld57
- Wild one
- aces-n-eights
- samsdad02
- Black1500Ram
- Lsujker
- Bandit517
- Beaniam
- jeff_rey
- Curmudgeon
- Hardracer
- Dontra
- tjfdesmo
- Edward Hands
- RamCares
- Michael Phipps
- HK1837
- Junglu22
- jeovanicorro
- Deercamp
- Cardsin2005
- Lil' Rob
- bucnut
- Rlaman
- Nails
- SkylarMelo
- diymirage
- FullForceRam
- jmr
- SRT Don
- Kaos1978
- reeltru
- jaflowers
- andres124501
- Ken226
- ZakkBaker
- jayquelin
- Sklovensky
- JHoward
- Baja1
- Lewybrewing
- wseco16
- Crusin
- Steel Chicken