multifunction switch going bad?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

bigtigga84

Senior Member
Joined
Dec 19, 2010
Posts
3,459
Reaction score
35
Location
dela....where?
Ram Year
2006
Engine
Hemi 5.7
So the other night on the way home, I had the high beams on and a car was comin so I clicked em off...... but they didn't go off. Had to pull off and click the switch a couple times to get them to go off. Little farther down the road and a couple times since, I'd go to turn the highs on and they wouldn't stay on. Had a similar issue with the exploder I had, but had no headlights at all unless I held the switch in. Something else weird goin on is the low windshield wiper fluid light comes on every time I drive, but there is plenty of fluid and the plug is secure.
 

RubberFrog

Senior Member
Joined
Jun 26, 2010
Posts
5,727
Reaction score
334
Location
Arizona
Ram Year
2019
Engine
6.4
Sounds like you need to replace the stalk. Have fun with that....

As far as the washer fluid- you just need to clean the sensor.
 
OP
OP
bigtigga84

bigtigga84

Senior Member
Joined
Dec 19, 2010
Posts
3,459
Reaction score
35
Location
dela....where?
Ram Year
2006
Engine
Hemi 5.7
10-4 on the sensor. Is replacing the stalk really that bad. Had the column spared on the slpoder and it didn't look that bad. I know its a completely different vehicle.
 

KGBIGCOUNTRY

Senior Member
Joined
Jun 29, 2010
Posts
13,309
Reaction score
474
Location
MECH, VA
Ram Year
2004 RCSB/2005 QCSB
Engine
5.7 / 5.7
I will ask my bro if there is anything in all data bout it for ya.
 
Top