intake?

Redtruck-VA · Jan 20, 2011

bigbadram1500 said:

And that is simply Badass!

Trupiano · Jan 20, 2011

glass3222 said:
I LOVE my Vararam Hemi Under Glass intake

If you have never seen a Vararam, here are some of my pics

Honestly if I wasn't concerned about flooding my truck with water with this ginormous hood and all the rain and flooding we get here in arkansas, I definately would have went with a vararam! Those seem so badass! But there's no way it would have worked for my truck.

Good pictures though!

bigtigga84 · Jan 20, 2011

infamous "*******" intake. i used 4"pvc. one street 90 from the tb two pieces of 24" pipe, 60 degree angle and a 4" adapter down to 3" spectre blue filter. it was loud as ****(no pun intended) till i started screwin with the exhaust. cb extreme pretty much drowns........ everything out lol. specially right before the tire

Redtruck-VA · Jan 20, 2011

Over on DT there is a long thread about Vararam and a lot of the results from their technical test proving how good it is over other intakes. But basically the engine has to suck air through whatever you choose to run. The Vararam is piped to some high pressure points which increase inlet pressure so it has an advantage over the average setup.

RAMpage · Jan 25, 2011

I have the vararam setup on my truck and love it. i can feel a good difference around 35mph. plus it takes care of whats uncovered when the hemi hats removed. actually trying to find some orange intake tubes to match the air cleaner cover but havent had any luck. as far as intakes go your really getting what you pay for compared to a k&n and other comparable cai's plus it looks so damn good. I have had people pull into gas stations just to talk to me about it when checkin the oil. for 399.00 i think its very worth it.

RAMpage · Jan 25, 2011

oh and trup do you think the vararam would fit under that sick ass hood youve got, ive been thinkin seriously about snaggin one this spring

Mike42488 · Jan 28, 2011

so i got the cai from ebay. i installed. heres what i got lol.\

doesnt really look right. its throwin my gas mileage off, any ideas why its doing that. its kinda jerry rigged in there, i may take big t's idea and hit up homedepot tomorrow. any ideas on hot to fix this monstrocity???? thanks fellas

ramhunter9 · Jan 28, 2011

I built mine out of poop pipe and slapped a K&N on it .... works for me and it was fun to build

bigtigga84 · Jan 28, 2011

^^ we the only ones on here with "poop" intakes?

OklaHemi · Jan 28, 2011

reset your pcm. see if that helps. remove the neg battery cable for about 10 min on the 08 i think, im not sure

bigtigga84 · Jan 29, 2011

you can use what you got so you didn't waste your money and just get a straight piece and a street 90 elbow. should fit together with what you have. gonna need a grommet and a half inch hole saw i think to put the IAT sensor in the poop pipe

badfish888 · Jan 29, 2011

bigbadram1500 said:
[/QUOT

What the hell is that, and how, where do i get one. It looks like you feed you truck small children through that thing

Sharp Charge · Jan 29, 2011

That looks like the infamous Ram Hammer.

0212353 · Jan 29, 2011

close, its a BFI - same design, same ponzi scheme ********. Good luck getting one, your best bet would be to look for a used one on the forums.......the new ones (composite material vs the metal shown above) went through the same BS to get them to customers (ie, you pay now.......get it it in 3-6 months).

Mike42488 · Jan 29, 2011

OklaHemi said:
reset your pcm. see if that helps. remove the neg battery cable for about 10 min on the 08 i think, im not sure

i took off both pos and neg for however long it took me to install prob bout 20 min. didnt work. then last night i left both pos and neg off over night bout 6 i'll see by the end of the day if that worked....

weedahoe · Feb 1, 2011

bigtigga84 said:
^^ we the only ones on here with "poop" intakes?

No, here is mine

Bluesmoke91 · Feb 1, 2011

lol poop intakes hahaha

moparman33 · Feb 6, 2011

just like dan a.k.a. the assassin said, you wont see big gains from an intake. add a intake and exhaust you'll be able to tell a difference, but still will not be anything huge

bigtigga84 · Feb 6, 2011

show off lol. how did you fuse your pipes together

weedahoe said:
No, here is mine

Redtruck-VA · Feb 6, 2011

Nicely done....

intake?

Senior Member

Registered User

Senior Member

Senior Member

Member

Member

Member

Attachments

Senior Member

Senior Member

Supporting Member

Senior Member

Senior Member

Senior Member

Vendor

Member

Banned

2nd GEN Site Mod

Senior Member

Senior Member

Senior Member

Similar threads

Forum statistics

Share this page