spoon059
Senior Member
- Joined
- Jun 30, 2015
- Posts
- 496
- Reaction score
- 343
- Location
- Just north of Washington DC
- Ram Year
- 2015
- Engine
- 6.7 CTD
I installed a Pioneer AVH-280BT in my Ram to replace the stock low end radio. I tapped into my backup camera signal wires and ran that RCA cable to my radio and the picture was pretty distorted. Thinking it was a poor connection due to tapping into the signal wires, I got an aftermarket camera and ran a dedicated RCA from camera to the radio. Picture was okay with the truck off, HORRIBLE with it turned on.
I used the Metra 95-6518B installation kit for the wiring. My truck is the 6.7 Cummins. Is it possible that my ground wire isn't substantial enough and I am getting some electrical noise from the diesel engine? I am thinking about supplementing the ground wire connection by adding another ground wire to tie in.
Am I just wasting my time here, or is it plausible that the ground wire isn't enough?
I used the Metra 95-6518B installation kit for the wiring. My truck is the 6.7 Cummins. Is it possible that my ground wire isn't substantial enough and I am getting some electrical noise from the diesel engine? I am thinking about supplementing the ground wire connection by adding another ground wire to tie in.
Am I just wasting my time here, or is it plausible that the ground wire isn't enough?