The way I'm reading the RF page, there will be a plug-n-play harness receiver for the giant plug that provides input to the Alpine amp. The DSR-1 will receive the full/raw signals from the head unit and be able to interpolate the CANBUS signals.
Then out of the DSR-1 you can connect a new amp via RCA's. And then run your speaker wires from your new amp to the original Alpine output harness (which at this point is essentially just plug with all the indivual speaker wires neatly organized that prevents a million wire taps).
Any BS flags going up on my logic?
Then out of the DSR-1 you can connect a new amp via RCA's. And then run your speaker wires from your new amp to the original Alpine output harness (which at this point is essentially just plug with all the indivual speaker wires neatly organized that prevents a million wire taps).
Any BS flags going up on my logic?