Ramforums

__________________

that's a good question. I'm gonna take a guess(remember just a guess) and say they should work because the amp interface is just an inline "splice if you will" of speaker wires to get the rca connections

__________________

They work, but I get a whine noise, not engine whine, just white noise that is present in dash and doors until volume is at 4 or higher. no distortion, does not react different if engine running or not. I believe that I will be able to resolve the issue once I run new wire from amp to each door. Currently using factory wire, and I believe that radio is still pushing power signal over same wire. When i turn radio off, whine goes away.

Anyway, lol... I have Lockpick v3 and Pac amp addon harness.

__________________
2009 Dodge Ram, 2006 Dodge Charger

I wonder if I will have the same issue, I just want it for my subs,

__________________

i added it for a 4 channel amp and a 2 channel amp. I have front rca going to front 1/2 of 4 channel, and the rear going to sub amp, which has a full range pass thru that goes to rear 1/2 of 4 channel amp.

confused yet...lol

anyway, I tried y-cables, but that was a FAIL....lol
Also the way i have it now, I get true front rear fade and true left and right balance.
Would like to move to a 2 in, 3 out crossover, and then run front and rear to 4 channel, and sub to sub.

For your application, you should not hear any feedback, and should be fine. When you decide to add power to your doors, then you will have this issue unless Im just that unlucky..

Good Luck
Send pics

__________________
2009 Dodge Ram, 2006 Dodge Charger