Remove image in rear view mirror?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

kabong57

Member
Joined
Jan 11, 2017
Posts
47
Reaction score
10
Location
Central IL
Ram Year
2017 3500 SRW 4WD Reg Cab Long Bed
Engine
6.4L
Swapped out a RA1 for a RA2 uconnect. used a harness from Mpgrimm2 to divert camera signal from I340 connector to the radio plug which works great. Now have rear view image on the radio screen . When I shift in to reverse, I have an image in the rear view mirror showing camera disconnected. How do I disable this?
 

Mpgrimm2

Senior Member
Preferred Vendor
Military
Joined
Mar 30, 2014
Posts
6,085
Reaction score
4,167
Location
SC
Ram Year
2022 Ram 1500 (5th Gen)
Engine
5.7L
Swapped out a RA1 for a RA2 uconnect. used a harness from Mpgrimm2 to divert camera signal from I340 connector to the radio plug which works great. Now have rear view image on the radio screen . When I shift in to reverse, I have an image in the rear view mirror showing camera disconnected. How do I disable this?
Remove pin 6 from the i340 connector (Lin Bus CBC 2). That should do the trick. Be sure to tape it up.

M² Mods - From my non Flammable S7!
 
OP
OP
K

kabong57

Member
Joined
Jan 11, 2017
Posts
47
Reaction score
10
Location
Central IL
Ram Year
2017 3500 SRW 4WD Reg Cab Long Bed
Engine
6.4L
Thanks, wish I knew the proper way to remove the terminals on the I340. Slide the lock plate out and 2 out of 3 of them released very easy with a dental pick. The 3rd one acted like it was glued in there. At least your harness installation worked great.
 

Mpgrimm2

Senior Member
Preferred Vendor
Military
Joined
Mar 30, 2014
Posts
6,085
Reaction score
4,167
Location
SC
Ram Year
2022 Ram 1500 (5th Gen)
Engine
5.7L
Thanks, wish I knew the proper way to remove the terminals on the I340. Slide the lock plate out and 2 out of 3 of them released very easy with a dental pick. The 3rd one acted like it was glued in there. At least your harness installation worked great.

Don't slide the plate out all the way, only about 1/8". I didn't have these pictures before but it sounds like you figured it out for the most part.
c98c2282b7065eaec11c8fc60c5e0cce.jpg
edf250d6fe8728a076380267b70dc6ea.jpg
50388294727365b98b2de28e78ab0e82.jpg

M² Mods - From my non Flammable S7!
 
Top