I recently had my bumper replaced which required me to unplug all the parking assist sensors, i got my new bumper from a junkyard. i was wondering if anybody new if i had to have them calibrated or something for them to work or if they were just bad sensors.
Service parking Assist
- Thread starter CamDep
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Veritech
Member
It could just be a bad connection. If one doesn't connect properly the whole thing errors out. You could try getting some dielectric grease for the connection points and give that a shot. You can also start the truck, place it in drive (or reverse for rear sensors) and have someone hold the brake while you check each sensor (get down close to it and listen or feel for the sensor to tick).
