Merc225hp
Senior Member
Do i need to order a whole new dizzy or can i just get a replacement gasket?
Just get the $1.99 gasket.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Do i need to order a whole new dizzy or can i just get a replacement gasket?
14ga wire with relay. Only need to put the fuse between the battery and relay. If you wanna be real cautious you could put one between the battery and switch too since you have to wire the switch into the battery too.
And you don't need to cut the mesh out....just make a ghetto bar like I did.
I bet you could drain and flush a couple times and all that nastiness will clear up.
Just get the $1.99 gasket.
Where can i get that? Haven't been able to find it
It is....which is why you change the fluid a couple times...that is if you get it somewhat operational....you know...enough to drive it.I thought it was a terrible idea to get a flush on these trannies? thought I heard that somewhere....
I have been racing any car or truck that wants to race since the drop lol it hugs the corners like a race car!!!
Raced a nissan truck today and a honda accord
Not bad. One of the better installs I've seen. Good job. How are the round lights btw.
Bet it drives better, yah?Since my last post in this thread, I built step bars for my short wife to climb in. Then I removed the front 2" spacers on my springs, removed the add a leaf from the rear, had all the ball joints and tie rods replaced with moog parts, got a new track bar. 4 new procomp 35" tires. With new shocks all around.
Monday I hope to replace my leaking power steering box and the tie rod that connects to my Pittman arm. I'm hoping that solves my sloppy steering wheel. And the knock noise I have now when turning the wheel since the new balljoints.
Most of my **** is stock I think......not sure. lolBeen a while man.
Not much of a fan of Moog anymore... They quality control has been seriously inadequate recently. Many of my parts from them failed. Many others have reported the same. I've since replace all of those parts though
Says it's not ready for viewing.
that's some **** gonna upload it to yt
sent from my brick using clay
Works now. Runs good.
ahh yea me and dad are ****** it up. he's the one in the vid saying it's got power lol
sent from my brick using clay
You can't say "T@lkin" on here. lolz don't forget that. And I know...he sounds old as hell.
So I guess it shifts and holds well now?
he'll be 39 in august. hell yea it stalled out coming back shifting it from reverse to drive.
sent from my brick using clay
He sounds old. lol Like 60s.
That's weird.
i guess all the drugs, drinking etc did it to him. yea just need to drive it more.
sent from my brick using clay