LKQ/Keystone Platinum Rear bumper quiality/fitment ?

Joe.G · Jun 12, 2015

Hi, I have a really clean 2004 Ram 1500 SLT with the Painted bumper, The only real rust issue I have with the truck is the rear bumper is starting to rust a bit and I would like to replace it.

How do the LKQ/Keystone platinum Rear bumpers fit? I can get them for about $100 less then the Factory, My Buddy got a Rear Bumper from JC Whittney and I am not a fan of how it fit and I don't wan the same issue, I hear the LKQ parts fit nice just wondering what you guys think thanks.

DodgeTx · Jun 13, 2015

I have never heard of this bumper, do you have a link?

If you'd rather keep stock bumper, Go to or call a Ranch hand store they usually keep the old bumpers and are usually in good shape. Most of the time they'll sell them for $100 front or rear.

also a 2004 is 3rd gen ram but this info ^still applies^

Joe.G · Jun 14, 2015

They deal in replacment parts for autobody shops.

Joe.G · Jul 12, 2015

Ok, so first bumper I order my friend who owns the bodyshop paints it all bumper looks great go to swap it on and the OEM Step pad don't fit ( Bumper fits on truck fine ) , Order there Pad and it fit's just like the OEM, Order a Complete bumper assembly pad and all from same place Pad fits better but not great, Do a trial fit before painting and bumper is off side to side, sticks out about an inch on Right side and is in about an inch on left side.

Sending both back and ordered a OEM bumper from East coast Mopar, I hope to see it early this week, And I think it comes with a new OEM Pad, I hope this fits right.

Only rust issue on this truck is the rear bumper the rest of the truck is very clean.

Joe.G · Jul 23, 2015

Finally got it back together new OEM Bumper and Pad, The OEM bumper did come damaged and it was not from shipping it was from the stamping process both sides were wavy and needed to be repaired, I called up East coast Mopar and they said they would either send me a new one or help cover the cost to get the damaged one repaired so i went that route.

I must say that Andy and Denny from www.eastcoastmoparts.com are great bunch of guys to work with and that is the only place ill shop for mopar parts from now on.

Joe.G · Jul 27, 2015

Mine was Primed from factory, I painted and cleared it front and back and then I put a clear chip guard like the factory uses on lower part of cars and trucks, I used this on the inside. I did notice that the new bumper seemed lighter then the Original one and also the aftermarket one.

LKQ/Keystone Platinum Rear bumper quiality/fitment ?

Joe.G

Senior Member

DodgeTx

Senior Member

Joe.G

Senior Member

Joe.G

Senior Member

Joe.G

Senior Member

Joe.G

Senior Member

Similar threads

Latest posts

Members online

Forum statistics

Share this page