How are bed lights mounted?

brianw0048 said:

I was trying to remove the factory bed light to add some additional LEDs...I've removed the two screws but it still won't come out of the bed. How are these things mounted??

Sent from my HTC6545LVW using Tapatalk

Click to expand...

brianw0048 said:

I was trying to remove the factory bed light to add some additional LEDs...I've removed the two screws but it still won't come out of the bed. How are these things mounted??

Sent from my HTC6545LVW using Tapatalk

Click to expand...

Brewdawg said:

Did you have any luck getting them off? I am trying to do the same thing.

Click to expand...

brianw0048 said:

They were held on by screws and double-sided tape. I only took the passenger side light off and wired in a red LED strip.

Sent from my HTC6545LVW using Tapatalk

Click to expand...

RBAT said:

So you tied your additional lights into the factory bed lights and have no problems? I realize that LEDs are very low current draw but some of these circuits are pretty sensitive. Just wondering if that much added could be an issue.

On a side note, when I was scouting drain locations for my tonneau cover I looked up into the stake pockets from underneath and noticed the connectors for the bed lights. I did not note at that time whether I could have reached them to disconnect them from below. If so, it may be possible to make connections without removing the lights from the bed.

Click to expand...