Very much alive [emoji16]
Since COVID happened we've been working ridiculous O.T. mainly on Essential Services Type Helicopters all while trying to maintain our normal / regular customers [emoji106]
Sent from my SM-G930V using Tapatalk
Think Long & you'll think wrong Sir !
It's simple REDLINE 5W-30 is the clear choice [emoji106][emoji106]
My truck 2014 5.7L ( with 95kish ) has been on Hemi Honey for about 70k and this oci is gonna be about 10k probably 9.5k ish , I'll be posting my Blackstone Labs report here...
I believe so but it's been a while since I did this .....go to my original post and look at step 3 . The higher you support the frame on jack stands will allow you to drop the rear end further for sure [emoji106] and obviously a low profile jack aids in this as well .
Hope this helps ...
Heat is your friend , a heat gun or a small bottle torch .
Try to concentrate the heat on the part you want to expand ....only hot enough that you can't touch it for more than 2-3 seconds then use the separator right away .
Hope this helps !
Sent from my SM-G930V using Tapatalk
Redline Products Rock !
Their oil products are the best performers on the market today and have been quietly the best oil product for over 20 years imo [emoji106]
REDLINE oil will outperform or perform just as well as any oil product available ....period. so why not just use everything...
After market does not work with the factory radios as far as I know .
Best bet is to purchase the OEM kit and install it ....pretty easy to do and works 100%
Sent from my SM-G930V using Tapatalk
I just seen Tach_tech commented above .....I've seen many of his post and he is spot on [emoji106]
From what I understand he is a Ram technician .
They didn't start The new 10 yr coolant until 2013 .
Sent from my SM-G930V using Tapatalk
Unfortunatly Dealership technicians would likely never have figured this out .
Folks like you figure these things out .
I have a dealership near me that would figure this out ..I'm fortunate in that way ...even though I'd likely just do it myself [emoji16].
they are impressive...
Sometimes it is the invisible things that cure all [emoji106]
Man I've been there too dad gum may times .....
I'm so glad I could be of some amount of help ! You didn't need any help at all ...it was easy to see from your original post you would figure it out ....sometimes people like you (...
No sales code needed at all [emoji106] ABSOLUTE plug n play .
As far as for the mic harness just purchase it from your dealer , it's under $30 it plugs in on the Right side theres a connector that's behind the passenger air vent . Easy access is to remove the glove box ( hands only) no tools...
Typically this would be a blown F95 fuse ....since you've verified the fuse then I'd do the following :
1) Absolutely verify your ground wire at the existing ground location with an ohm meter over to the right hand fender , should be less than 3 ohms .
Even if the ground test good go ahead...
Is the 2018 maps still the latest available?
Any idea when a 19 Nav update would be released ?
Thanks in advance [emoji106]
Sent from my SM-G930V using Tapatalk
I did the same thing today ( BIG SHOUT OUT TO MPGRIMM2 FOR HIS KNOWLEGE AND HELP ! )[emoji106] only my 2015 RA4NA had old software 14. Something so I installed the 17.43.01 sw then after a short drive and a couple power cycles I then installed the 18.45.01 sw .
Any of you guys no what the...
I always try to purchase MADE IN THE USA type products ...usually pay more and almost always a better product [emoji106]
Sent from my SM-G930V using Tapatalk
This may have went to a different monitor ? Probably just a cheap aftermarket kit to a separate monitor and not the radio .
Pull the radio and see if sockets #31 ,32 ,33 are populated . If not the camera is not wired to the radio [emoji106]
Sent from my SM-G930V using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.