Search results
-
A
3rd Gen Service and Parts Manuals
I have a question about torsion bars. It states "Torsion Bar sales codes will be found on Vehicle Identication Number [VIN] Sales Code Listing." Where do I find that Sales Code listing on my truck?- AlexP
- Post #32
- Forum: 3rd Gen DIY
-
A
Need help with name of seal for replacement
Hello, Thank you for providing that information. I will research it further, but thought it may be an input shaft seal after research. Do you happen to know where the best place to purchase this with highest quality is? -
A
Need help with name of seal for replacement
Hello all, I have a photo showing where there is a leaking seal at the front of the driveshaft. I don't know exactly what the terminology for this seal is, and if anyone could offer some input it would be most appreciative. 05 Ram 1500 4WD 4.7L SLT -
A
Request for help in covering chrome bumper with black bumper cover
Darn it, why does something I need have to be far away!? Where are you located? -
A
Request for help in covering chrome bumper with black bumper cover
I live in Massachusetts. I'm going to make one more attempt to fit the cover on before spending hundreds of dollars on the backing pieces and fasteners. The bolt holes line up on the cover I received, just seems that there is something in the way not allowing me to install. -
A
Request for help in covering chrome bumper with black bumper cover
Thank you for that link. I was viewing that yesterday and could not find a lot of differences or a way to remove the chrome front as shown in the second picture I posted. I was told this was an all in one design and would have to get the "make-up" for a sport bumper include the backing to do the... -
A
Request for help in covering chrome bumper with black bumper cover
Hello, Thank you for the response. I will post a photo (I hope it comes out) that shows the point where I'm at. Any pointers on what the next step is or what needs to be removed? -
A
Request for help in covering chrome bumper with black bumper cover
Hi all, I have a 2005 1500 SLT with the front and rear chrome bumpers. I received a black bumper cover which looks to have the same bolt patterns but still appears to be a few inches off from attaching over the chrome. I removed the air deflectors, and the step pad as well as the silver (color... -
A
P0344 & p0016 please help!!!
Hello, I have attached a diagnostic list which may help you with the issue. Essentially this could be as simply as a Camshaft position sensor defect or crankshaft sensor defect, or it could be an issue with the tone wheel/pulse ring going bad. I hope this helps. -
A
Installed Spyder Halo headlight assemblies
427invader, do you have any other symptoms such as your turn signals not working properly, or parking lights/ running lights not working? Did all of the leds go out all at once, or did one go, and the rest went out? -
A
Installed Spyder Halo headlight assemblies
Hey m4mckeen, That looks really good. I like the present look, but once I get the truck to the next step it may be an option. The only thing I dislike about the Spyder headlights are the adjusting screws having to be accessed by removing the headlight completely. Makes the adjustments more... -
A
P2320 Ignition Coil G Sec Circ
Hello, Coil G will be for cylinder 7, and located on the driver side furthest coil back. I know that if you search for Wells Vehicle Electronics for the coil, they sometimes have a way to test the coil for possible failure. POSSIBLE CAUSES - Good trip equal to zero - (K342) ASD relay...- AlexP
- Post #2
- Forum: Engine & Performance
-
A
Installed Spyder Halo headlight assemblies
Hey all, I haven't been fully active on this forum lately, but two weekends ago I installed Spyder Halo LED headlights on my 2005 Ram 1500 SLT. Spyder part number for these headlights is: PRO-YD-DR02-HL-BK The outcome was very nice, and the wiring was pretty simple. There were two... -
A
Need help asap
P0869 Possible Causes - (F856) 5-VOLT SUPPLY CIRCUIT OPEN - LINE PRESSURE SENSOR CONNECTION - (T140) PRESSURE CONTROL SOLENOID CONTROL CIRCUIT OPEN - (F856) 5-VOLT SUPPLY CIRCUIT SHORT TO GROUND - (T140) PRESSURE CONTROL SOLENOID CONTROL CIRCUIT SHORT TO GROUND -... -
A
Tow mirror question
I have ordered mirrors from two separate vendors, and have not noticed discoloring. If you don't mind me asking where did you order the original towing mirrors from? I have used 1A Auto, and a Dodge Dealership through eBay for my 05 1500. -
A
P0456 code
This is for a small evaporative leak. - Missing or loose fuel cap - Incorrect fuel filler cap used - Fuel filler cap remains open or fails to close - Foreign matter caught in fuel filler cap - Evaporative Emission (EVAP) canister or fuel tank leaks - Evaporative Emission (EVAP) system hose... -
A
Need help with Po171 and Po172
Hello, - Faulty front heated oxygen sensor - Ignition misfiring - Faulty fuel injectors - Exhaust gas leaks - Incorrect fuel pressure - Faulty Mass Air Flow (MAF) sensor Read more: P0172 Dodge Fuel System 1/1 Lean Fuel System Rich OBDII Engine Light Trouble Code | Engine-Codes.com... -
A
2003 ram 1500 codes
Hope you got this fixed already, but if not please see below information from AllData. SYMPTOM P0442-EVAP LEAK MONITOR MEDIUM (0.040) LEAK DETECTED WHEN MONITORED Immediately after a cold start, with battery/ambient temperature between 40 °F and 90 °F and coolant temperature within... -
A
All Data DIY Info
Hey, I use AllData repair S3000 and I believe the information is helpful, but as KGBIGCOUNTRY stated sometimes is misleading. They provide instruction and removal by the book, but in most cases do not offer any secondary tricks on how to get the part removed or installed. -
A
Cts???
Hello, I hope this helps. Please click on the following link for a photo pointing to the location of the coolant temperature sensor on the 2005 Hemi. Coolant Temperature Sensor 05 Hemi gif by alexp1 | Photobucket The Engine Coolant Temperature (ECT) sensor on the 5.7L engine is located...- AlexP
- Post #2
- Forum: Engine & Performance
