Search results

  1. H

    driving without inner fender/ plastic wheel well

    So my truck got side swiped this weekend. No major damage. Only thing really messed up was the passenger side front bumper molding and lip. Plus the bumper is pushed in a bit on the corner. I took the lip and molding off. So now my plastic inner wheel wells are flapping. When I drove it home...
  2. H

    for you classic car guys (350 engine) question

    Wouldn't it need to be flared?
  3. H

    for you classic car guys (350 engine) question

    I know that this thread doesn't belong anywhere in the forums but I've been searching online with no luck. I need you classic car guys help with my high pressure power steering hose fitment. I have a 350 engine in my nova. I put on a new ps pump. The nova ps high pressure hose fits onto the...
  4. H

    What did you do to/with your second gen today?

    Used it to jump start my 78 Nova. Alternator and battery is dead.
  5. H

    what is this???

    When I plugged the hole with my finger, the.idle dropped. Unless my idle is running too high now.
  6. H

    what is this???

    I saw this today on the driver's side engine. Sucks in air. When I covered it with my finger, the idle would drop. Can't remember if I've seen this before. What should I do? [/IMG]
  7. H

    misc plug

    What's your lift and tire size?
  8. H

    Door panels and speakers

    I'm running all Rockford. 6x9 doors and 5 1/4 rear walls. The pins, the pointy end goes into the door while the two circles slide on the door panel side. Referencing on the picture, just have the pointy tip face outward. Is that what you were asking?
  9. H

    Behind the seats..

    I had to remove my bottom tray for my amp. Once I bolt it onto the rear panel, I'll put it back. Mine also came with a net. Any of you had a net too?
  10. H

    AC vent issue

    It's a possibility.
  11. H

    newer model emblems?

    Exactly what I was looking for. Thank you!
  12. H

    AC vent issue

    I'm not sure how long has this been going on because I hardly use my AC but I noticed when I put the AC direction control to "blowing in your face" picture, I'd get it through my feet area. As if it won't change. Also, if I turn it to "blow on your face and feet" mode, I'd get more air on my...
  13. H

    installing aftermarket hu with infinity

    It should show on the wires. If not, check behind the labeling.
  14. H

    newer model emblems?

    Has anyone tried to put on a newer model dodge ram emblem from the tailgate to our gen models??? I've always thought about doing it since it's not actually screwed on. If it's done, any pictures?
  15. H

    Is my Dash to far gone?

    That's funny. When I was installing my new head unit, it was easy to route wires from the top to bottom. Lol.
  16. H

    For all you northern/ snowy state guys, canada you too.

    How much that cost you? I have existing surface rust and I'm looking for a way to "stop" it in its place. Already my rear bumper brackets are peeling from corrosion.
  17. H

    Rear wall panel removal help

    And on the floor. I believe 3. L,m,r.
  18. H

    Rear wall panel removal help

    I just want a clean look. I don't want huge holes showing where my wires will be coming out from. I'll think about the drill since I can just make it fit the width/ girth of the wires. But behind the panel, I want the wires to be secure and not dangling or swaying side to side. I'm thinking...
  19. H

    Rear wall panel removal help

    Wow, lucky! I went to the jy Saturday and removed a panel from a ram I've found. Removal: Remove the floor tray screws and all trays. Remove pillars/ panels. They pop out. There's screws that need to be removed which hold the panel in place. You can remove the speakers for easy panel removal...
  20. H

    Is my Dash to far gone?

    How hard/ easy was the removal and install of the lmc dash??
  21. H

    Trans jerking when going into reverse

    My 97 5.9, auto trans only jerks when going into reverse but everything else is fine. It's easy to shift to reverse but theres a light jerk and sound when shifting to reverse only. Anything to be concerned about? Fixes?
  22. H

    auto shift knob

    How did you even get the knobs off??? I've been trying for the longest.
  23. H

    Rear wall panel removal help

    I want to mount my amp on the rear wall panel so it's not touching the floor just in case I leave my windows down when then it rains, someone stepping on anything and I like to put things behind there. Initially, I had it laying behind the passenger seat because it's too long to be under the...
  24. H

    For all you northern/ snowy state guys, canada you too.

    How much that cost you?
  25. H

    Subwoofer Location?

    The bracket bolts that bolts your seat to the floor. Bracket to floor bolt.

Latest posts

Staff online

Members online

... and 14 more.
Total: 1,458 (members: 64, guests: 1,394)
Robots: 1,540

Forum statistics

Threads
195,592
Posts
2,872,219
Members
156,378
Latest member
Bsil90

Share this page

Top