In this day and age you would think that someone would come up with a replacement air card. its not that difficult to change. I have had my RA4 apart to change the screen and it is right there...
The Sierra wireless car went end-of-life when they phased out 3G. All you have now is a radio with AM FM and SAT (maybe NAV) capabilities. And if it was still working (3G), if the radio is not original to the truck it still wouldn't work.
I just replaced mine on 1/27. I already had the seat mod to allow the seat back to unlatch from the back wall. Just remove the 3 car seat tethers, 2 bolts on the shoulder strap and 3 push pins. The rear wall card comes out.
My originals had many flaps missing. Pulled out through the opening. The...
Without knowing the actual code no one will be able to help. Get yourself one of these https://www.harborfreight.com/zr4s-obd2-code-reader-57663.html so you can be empowered to know before you get ripped off.
This link to eBay is an RA3 nav activation for $160.
eBay LINK
Back is 2018 I activated the Nav on my RA3 from Navi-expert-UK for $125 but it looks like he is out of uconnect updates right now.
The rear tires are under inflated. The pics show wear on both edges. The front is alignment related if it is just one edge. If both, then they too, are under inflated.
The USB port in the dash is charge only. When my 5” radio started rebooting I replaced it with an 8.4 setup. Got all info on this forum and harnesses from M2Mods (forum vendor)
PLA is OK up to about 130F. I found that parts in direct sunlight stay stable if made from or painted a light color. I have a silver painted mount on the dash of my RAM and it hasn’t melted. Going on 2 years. On the other hand I have a black emblem mounted outside and it deformed from the hot...
I have my 2015 3500 that I retro'd an RA3 into in 2018. When I did the project I installed all new HVAC controller and single zone center stack. No issues at all until recent cold snap. The audio starts normally but then shuts down either completely or after a few on-off sequences. Audio remains...
You need a CANBUS emulator. There is someone on ebay selling them specifically for VP3 VP4 but it should work for the 5" as they all work the same. Its $150.
It has been a while. Check Vehicle Config 2: Compass Temp. Display Present: (Set) (Not Set)
Other compass settings (should be preset) VC2: Compass mounting angle: 765.00 deg; VC2: Compass mounting orientation: Right side up.
In my 2011 Challenger the compass module is in the Homelink console. Maybe the same with your RAM, so if you dont have it you might need to add it. I did activate the compass with AlfaOBD, successfully.
If this is an original EVIC then your shift linkage might be out of adjustment or whatever senses position is not working.
I have an 8 speed EVIC in a 6 speed 3500 and the P flashes with no other problems because the EVIC apparently does not see the appropriate park signal.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.