Search results
-
Y
Dodge ram spec charts and wiring
I bet I've tried that page a dozen times. It never works. -
Y
Wood car ramps
If you want to use wood ramps, then use them. Just buy 2x12's and start with say a three foot piece and cut the next two inches shorter and so on. Just stack up as many as you want. Cut them at an angle if you want, but not really necessary, in my experience. Screwed together the chances of... -
Y
8 Speed 8PH70 Question
Huh! If there is no dipstick, how would one know it was shipped a few quarts low?- yrral
- Post #59
- Forum: Engine & Performance
-
Y
2015 Ram 1500 Sport (Seats Bubbling/Warping
bubbles So did you put heavy objects on the seats?- yrral
- Post #5
- Forum: General Discussions
-
Y
Fender
I am 6' 3'' and sit pretty straight, but cannot see the passenger side fender in 2016 Express. Does any one sell a pole like device to attach to the lower part of the fender that sticks up enough to be seen? I admit that would be somewhat tacky, but I find myself backing and filling a lot...- yrral
- Thread
- Replies: 9
- Forum: General Discussions
-
Y
Standard Transmission trucks?
Manufacturers don't put manuals in their trucks because they don't like replacing the clutches under warranty. Burned out by drivers who want it but can't operate the clutch correctly. Even operated correctly, it is a wear item, so it is hard to put a warranty on them. And today there is...- yrral
- Post #10
- Forum: General Discussions
-
Y
Looking for help on product advice for paint correction (PICS INSIDE!!)
Put bed liner on the whole thing. -
Y
Frog in my fuel tank
I'm a bit lazy. It the truck is running well I would just let his bones lay where they are. I can't see how any parts could get past the filters and screens to the engine. Funny though! -
Y
Tool Chest / Roll Away Cabinet
Tool boxes are a curious purchase. I've had/have tool boxes with ball bearings and without. Two boxes that I specifically remember do not have ball bearings are the two Kennedy chests that I have. So not sure if ball bearing are required. In my area if one wants the best big box available... -
Y
Just got new tool chest, now need tools!
First I like tools. I have virtually all I need though. Some I've owned 50 years. If I were to start over, I would go to Harbor Freight and get one of every HAND wrench, using sales and coupons. If they work for me fine. If not I would buy Craftsman or Stanley, not Kobalt. Gearwrench is ok...
