Search results

  1. RAMTRPR

    Cam/Lifter Swap Lessons Learned

    So i literally got the tick about two blocks from my house and shut the truck off and coasted/had it towed the rest of the way home. I have a greene racing custom cam and I am hoping I can get away with just new lifters. Ram rough right before I shut it off but no misfire codes at all. Can I...
  2. RAMTRPR

    2022 Power Wagon 8-speed Tranny not warming up?

    I have the 8HP70 swapped into my 09' and it never gets above 150F even after driving it for like 3 hours. I have an inline Thermostat to put in it, but have not done so yet. I hear these things like to run between 165-185 to shift perfect and run smooth. I can say that when cold Mine shifts like...
  3. RAMTRPR

    OIL FILTER RELOCATION

    Does mounting the filter vertical vs. horizontal make any difference? Seems Horizontal would be much easier to catch the oil as it comes out.
  4. RAMTRPR

    Knight Rider LED strip

    I have the 3 LEDs in my hood that I am wiring to come on when I use my sound effects I wired up. Only use at car shows and such and the LEDS are white. This would be cool though. Does it chase back and fourth when on as well?
  5. RAMTRPR

    Adding Rear HVAC Vents

    You could add in an extra blower motor under the center console to force the air out :) DIY job for sure.
  6. RAMTRPR

    37's and 3.92

    Now that I have the 8hp70 swap the 4.56 gears are a bit high :). If I slowly accelerate from 0-45 I can go through the first 4 gears supper quick. My 4.56's I believe are starting to whine at about 50-60mph, so I need to get them checked out. 4.56's are not an OEM cut so I know they are a bit...
  7. RAMTRPR

    8 speed swap

    Hey guys I completed this swap in my 09’ ram and love it. My only 2 issues now are: 1. Installing the in line oil thermostat from improved racing. Can I jut clamp off the lines, cut and install? Never put one in. 2. My remote start does not work. Russell said I need to make sure the TCM has...
  8. RAMTRPR

    Rear air ducts

    I know this post is old but looking to do the same in my 09. Any final write up on if this worked and if the #4 part was needed?
  9. RAMTRPR

    Adding Rear HVAC Vents

    I think if you find these 2 pieces don't you just tie into the vent under the radio and it goes straight back?
  10. RAMTRPR

    Light bar and reverse light install.

    So what Wire did you end up hooking up the switches so the one LED only comes on with Lights on? I am getting ready to install my switch Panel tonight for all my fun lights :)
  11. RAMTRPR

    Horn randomly keeps honking??

    My 09 just started this as well. It does the double beep like the remote start is trying to be activated. It does it daily but only once or twice during the day then stops. Can I use AlfaOBD to reset anything?
  12. RAMTRPR

    Front Camera Install on 2019 1500 Classic

    I am going to add 3 cameras to my 09 But I am getting the Wilco Spare tire carrier so I cant do the tailgate handle camera as it will cover it up. I am thinking aftermarket license plate mount off to one side of the plate or at least just past the spare tire, then the 2500 LED CHMSL Lamp, then...
  13. RAMTRPR

    6.4 intake manifold swap

    Got the map sensor figured out. The P2017 went away but came back again now. I need to do some wire testing and I might just hardwire in the Extension Harness I got to eliminate connectors. My SRV motor was bad and stuck this time as well so I swapped that out. Attached the pinout for the SRV...
  14. RAMTRPR

    Remote start switched power wire location?

    Can you not find a. Unused fuse location in the TIPM and wire it there. Then use AlfaOBD to turn that feature on with engine run?
  15. RAMTRPR

    8 speed swap

    Yeah my cooler now is built into the AC condenser. I am going to have my lines cut and flared then add lines back to the trans. Hopefully I don't have too cold issues. Don't ever drive the truck crazy when its cold and I'm in California so it never gets "really" cold. :)
  16. RAMTRPR

    8 speed swap

    I have ordered most of the parts for my 8spd swap, but had a question on the cooler lines. Is it easier to cut and make your own from the current trans cooler or buy the 8spd truck lines to try and hook up to the trans? Also I am a 4wd 2009 so I think my Transfer case is a NV243. I was told I...
  17. RAMTRPR

    37” spare

    I had to trim the corner of my sport bumper by about 2". Other wise they fit great.
  18. RAMTRPR

    37” spare

    I have 37X12.50R18 Falken Wildpeak AT3W's which are actually 36.6" tall. I was wondering if I could fit that under there. If not since I have onboard air, could I run an aired down 35" as a spare and just air it up and run it up front to get to the nearest Tire store?
  19. RAMTRPR

    6.4 intake manifold swap

    I just completed my 6.4 Swap but waiting on my S&B to show up. I am getting a couple errors now after installing Jay's Tune for it. Any thoughts on what it could be?
  20. RAMTRPR

    8hp70 heater bypass

    Any type of thermal bypass for the 545RFE?
  21. RAMTRPR

    True or False:

    On a long trip it is nice to put in in ECO also and just let your foot rest on the pedal. Wont do much but maintain your current speed. PC works great in both directions. :)
  22. RAMTRPR

    True or False:

    I have 37's on my truck. No PC no spin. Add PC and highest setting I can spin all I want :)
  23. RAMTRPR

    Simple Bed Rails

    Using these rails, what would be my options for a bed cover that would work with them? DEE ZEE DZ 99704B Hex Side Rails And the DEE ZEE DZ99799TB Hex Cross Rails
  24. RAMTRPR

    Problem with OEM trailer brake controller install

    So I followed all the instructions, but my controller wont come on unless my lights are on :). I am guessing the power wire just needs to be tapped into a different wire. thoughts?
  25. RAMTRPR

    What did you do with your 4th Gen this week?

    I have 18x9 with 37x12.50R18. Not too bad looking :) my lift is 8” Sent from my iPhone using Tapatalk Pro
Top