Search results

  1. bluwarguy

    Multiple Misfire

    Just replaced that not too long ago
  2. bluwarguy

    Multiple Misfire

    Over a month later, the problems are still persisting. I've noticed a couple different things however. The engine won't shake/misfire as bad when it's cold but as soon as it hits 180 it shakes bad. I've also noticed that at higher speeds, when I let off the gas there's a rapid ticking noise...
  3. bluwarguy

    Multiple Misfire

    My truck misfires at WOT (going up hills and things like that). The check engine light flashes then it'll stop when I ease off the gas and coast downhill. I checked the codes with an OBD reader and got Random/Multiple cylinder misfire, misfire on cylinders 1, 6, and 8. Now normally whenever this...
  4. bluwarguy

    Jerking at steady speed and cutting out while accelerating

    Bumping because it's becoming more severe
  5. bluwarguy

    Jerking at steady speed and cutting out while accelerating

    The truck starts fine and runs fine up to 25 mph, but above that, accelerating makes it cut out/sputter. Going uphill produces the same effect. At highway speeds it will jerk slightly and randomly. Turning overdrive off can make it worse. Flooring it up into the higher rpms produces some popping...
  6. bluwarguy

    RamForum Exhaust 2nd Gen Clips and Vids

    JEGS Off-Road Y-Pipe and nothing else https://youtu.be/7hTl8_grNk0
  7. bluwarguy

    Slight jerking/noise at steady speed

    MSD Coil didn't need an adapter, but its been on there since January. I've checked the codes and the only ones on there tell me my O2 sensors are missing, which I already knew. On my drive home I noticed it wasn't doing it on the highway at 55, but after I ascended a hill and started heading...
  8. bluwarguy

    Slight jerking/noise at steady speed

    Going uphill at 25mph would cause the popping sound and sometimes the exhaust noise would cut out for a split second
  9. bluwarguy

    Slight jerking/noise at steady speed

    It's got about 132k and drinks oil like water so I bet it's the plenum. I've had an incident last winter where it was misfiring horribly due to fouled plugs.
  10. bluwarguy

    Slight jerking/noise at steady speed

    A few days ago as I was driving around I noticed a popping noise (like popcorn) that would occur. It wouldn't happen very often and there was no effect on performance so I shrugged it off. As I was driving on the hoghway however, the noise became more frequent with tiny little jerks occuring at...
  11. bluwarguy

    Brown paint code

    I'll stick to an OEM replacement then
  12. bluwarguy

    Brown paint code

    Thank you! Just curious though, how will I regret it?
  13. bluwarguy

    Brown paint code

    Got rear ended by a Silverado yesterday by a kid I go to school with and got my bumper dented. His front end is completely fucked but he's taking fault for it. Instead of using insurance he just offered to pay for it up front so I made a deal with him that instead of buying an OEM rear bumper he...
  14. bluwarguy

    Cam install guide

    Is there a detailed cam installation guide? I keep looking online but they don't go into as much detail as I'd like them to.
  15. bluwarguy

    Cylinder 1 and 8 Misfire + unknown manifold code

    I'm betting it's my plenum. It's sucking oil FAST and with full synthetic it's getting expensive to keep up with. The manifold code was actually from my MAP sensor a while ago when I forgot to plug it back in. It hasn't misfired since though.
  16. bluwarguy

    Cylinder 1 and 8 Misfire + unknown manifold code

    I was driving to prom 2 days ago and accelerating hard when the check engine light started flashing. I immediately knew what it was doing so I pulled over and got out my OBDII reader to see what was misfiring. Both cylinders 1 and 8 had misfire codes and there was another one that said something...
  17. bluwarguy

    How to install a turbo like this?

    Here's where I found it: http://www.turbo-mopar.com/forums/showthread.php?64500-Turbo-kit-off-a-5-9-magnum-what-turbo-do-i-have
  18. bluwarguy

    How to install a turbo like this?

    I was looking around the internet for turbo setups for the 5.9 magnum and I found somebody with this: How would all of this bolt up?
  19. bluwarguy

    PCM swap

    I feel like the 01 will be better. Really your best choice would be to get the PCM for the right year and engine but running the 01 will at least give you a PCM for the same engine instead of a smaller one
  20. bluwarguy

    Is it possible to convert this manifold to EFI?

    Will this be cheaper than the FI Airgap they have? It's $599.
  21. bluwarguy

    How to install this bed light bar?

    Just saw it in person today and bought it. It's surface rust only, and it's extremely heavy and well constructed. I actually like how it looks on the long bed. It's constructed out of steel, and I'll do what you said to mount it.
  22. bluwarguy

    Is it possible to convert this manifold to EFI?

    Is this manifold possible to convert to EFI? https://www.summitracing.com/parts/pfs-55026/overview/make/dodge
  23. bluwarguy

    How to install this bed light bar?

    Today I get the chance of buying this for $75. If I don't like how it looks on my long-bed regular cab, I can at least sell it for more than I bought it for. But if I do like it, how am I going to install it?
  24. bluwarguy

    Overdrive Off Rumble Noise

    Oh thank god. I was NOT ready to pay for a new transmission if there was anything wrong with it. Thank you!
  25. bluwarguy

    Overdrive Off Rumble Noise

    When I use overdrive off, and I'm abover 45 miles per hour, letting off the gas produces a low rumbling noise until I get below 2k RPM. Is this normal? It drives completely fine it's just the noise.

Latest posts

Members online

... and 7 more.
Total: 1,105 (members: 57, guests: 1,048)
Robots: 1,737

Forum statistics

Threads
195,604
Posts
2,872,421
Members
156,416
Latest member
thomasjb40

Share this page

Top