Search results

  1. M

    Wanted-Help Installing Bilstein 5100 in DFW Area

    I can't remember the name of the shop but they are next to Universal Billiards in Farmers Branch TX on the service road just north of Valley View lane @ 635 / 35E. I had them install my 5100's and rear bilsteins with alignment. $250.00 Took a day to do but well worth the wait. I will check the...
  2. M

    KEY FOB NOT WORKING CORRECTLY

    Mine did that on my 2011, the small metal cups mounted inside to the rubber buttonpad came loose. I ended up ordering a new fob case and put my circuit board in it. Problem solved. Bought it on Amazon for like $20.
  3. M

    TIPM problems

    Yes they did and tested all circuits. If they find anything else wrong they will contact you and give you the updated cost if any. I was and am very pleased. He usually has a 24 hour turn around once he receives it. He has a lot of good info on the site to explain the process and problems...
  4. M

    TIPM problems

    My TIPM caused my battery to die on my 2011 or not start but turn over fine getting no fuel. The fuel pump relay went bad on it. Sometimes stay open (no fuel) or sometimes closed ( dead battery) I used these guys to repair it ( see link below). Took about 7 days total shipped both ways and less...
  5. M

    2011 1500 ST Recall notice, Column Shift problem.

    Hi all, I received a recall notice yesterday, on my 2011, 1500 ST 4x4 about a locking pin in the column shift that will not allow it stay in park properly? I switched over to a console shift, so I assume I don't need to worry about the recall since the parts described are no longer in use? :) MK
  6. M

    2010 Ram 1500 fuel pump fuse blowing at start up

    The fuel pump relay is integrated in the TIPM, I just had mine go wonky on my 2011. It is now being repaired as a new TIPM is about $1000 mk
  7. M

    Replacing center console

    Here's one on Ebay. 2013-2017 Dodge Ram 1500 2500 3500 Center Floor Console Tan W/ Brown Lid OEM Even though it says a 2500 in thge listing do a lookup to make sure it is compatible. Most of these guys have others available. I'm currently converting my 2011 from column shift to console shift...
  8. M

    Parasitic drain on battery problem

    i finally found my parasitic drain that has been killing my battery. It has been intermittent. My TIPM is going bad and the fuel pump was staying on after turning off the key. Also began have starting issues. won't start then will. Bottom line found a place that repairs the TIPM for about a 1/4...
  9. M

    Parasitic drain on battery problem

    Hi All, I am having a problem with parasitic drain on my battery. I know the steps to find the circuit. My Problem, I would like to get the part# for the wiring schematics manual for my truck? 2011 1500 ST 4wd hemi. Any chance of finding this? Thanks in adavnce, MK
  10. M

    Battery Dead, Fob stuck in Dash???

    Okay then, will get a new battery and hopefully move on. LOL!! Thanks for the quick reply. MK
  11. M

    Battery Dead, Fob stuck in Dash???

    Hi All, my truck battery is dead I mean no voltage what so ever and I am unable to remove the fob from the dash? Is this normal?? MK
  12. M

    Speedo recalibrate

    Think about it this way. if it is 3 miles slow then every 30000 miles you drive then it only shows 27000. :) From a resell standpoint you win. LOL!!!
  13. M

    Speedo recalibrate

    Damn that sucks, Good luck on the fix. I hope Discount is going to replace them for free and give you a refund.
  14. M

    Speedo recalibrate

    When Discount installed my new TPMS sensors,I had the same problem as you. The guy forgot to activate them. I went back and they activated them and all was good within about 2 hours. MK
  15. M

    Kenwood DNX-572 finally installed

    Okay cool. :)
  16. M

    Kenwood DNX-572 finally installed

    When you say it expired does that mean it no longer works? My old Garmin, it only cost to update the map. So i would figure it would be the same? MK
  17. M

    Kenwood DNX-572 finally installed

    I did a reset on the radio and all is working now. :) Had to add a Siruis Xm tuner as the OEm does not work with the Kenwood so they say??? mk
  18. M

    Kenwood DNX-572 finally installed

    It came with the head unit that I got from Coolemoff1. :)
  19. M

    Kenwood DNX-572 finally installed

    Yes that will be my next upgrade to this. :) Some how I didn't get the SiriusXm or the uconnect to work??? Will need to recheck my settings?? or wiring?? mk
  20. M

    Kenwood DNX-572 finally installed

    Programming the idata link took a little longer than I expected though. another pic LOL!!
  21. M

    Kenwood DNX-572 finally installed

    Finally installed my Kenwood dnx572 gps touchscreen DVD I got from Coolemoff1 in my 2011. I sure do like it. :) Now I just need to figure out the setups for stuff. Thanks man for such a great deal. Now I can start on the console swap. mk Sorry no pics of the install. :(
  22. M

    Alright guys.. BILSTEINS post your pics!!!

    Setting at 2.1. 265/70r17 ON STOCK WHEELS mk
  23. M

    Alright guys.. BILSTEINS post your pics!!!

    It should look like the install instructions say. MAYBE THIS PIC SHOULD BE A STICKY?
  24. M

    Pics of leveled 4x4 trucks with what size tire and wheels you are running.

    My 2011 just added the 5100s set @ 2.1 265/70r17 Wrangler Kevlars on stock wheels
  25. M

    HELP Bils 5100 install in progess, problem.

    Wow what a difference in ride quality. :) I'm very pleased with the results. Setting at 2.1. mk

Latest posts

Staff online

Members online

... and 17 more.
Total: 1,699 (members: 67, guests: 1,632)
Robots: 1,852

Forum statistics

Threads
195,596
Posts
2,872,331
Members
156,401
Latest member
jesmich

Share this page

Top