Search results

  1. V

    Muffler delete too loud

    I know the welds aren't the best looking, but as long as it's not leaking, I'm fine with it
  2. V

    Muffler delete too loud

    It may have been nothing, but it bugged me, so I got it fixed.
  3. V

    Muffler delete too loud

    I got a Magnaflow 12259 put in, and it sounds much better. Quiet when cruising, but has a nice rumble when accelerating hard. I will probably get some 5" tips on the future as well. This is the muffler installed. I asked about the rear weld, as it looks like the exhaust size gets reduced...
  4. V

    Muffler delete too loud

    I can get the stock muffler. Would that with 5" tips give it a little rumble? Or are the tips just cosmetic?
  5. V

    Muffler delete too loud

    Hi all! I got a 2019 Ram and the previous owner did a muffler delete, but kept the resonators. It sounds good, but has drone while cruising. What's a good size muffler to put in to get rid of the drone, but still have a nice sound?
  6. V

    Payload Weight

    I had done a Google search, but I got all kinds of different weights, just like here, between 1500lbs and 1900lbs. I'll be conservative and assume it's around 1600lbs, which should be fine for the block I need. I'll check my other doors for stickers as well. Thanks, all!
  7. V

    Payload Weight

    Hi all! I need to carry a lot of wall end cap soon and I can't figure out if my little truck can handle it. I have read about payload capacity, but all the estimates are different. My door sticker gives GVWR and GAWR, but not payload. Can I deduce it from the info on the door sticker? Or...
  8. V

    Tires question

    I just installed the RC 3" kit on the front, which levelled it, so no block in back. I wanted to get some good tires, but I have the baby 4.7 and 3.55 gears. If I install some 305s, will it be crazy slow? I have a magnaflow exhaust, k&n intake and superchips on tow tune if that will help me...
  9. V

    RC 3" lift plus spacers?

    I am getting ready to pull the trigger on the RC 3" lift. https://www.amazon.com/gp/product/B00B2A8ZOU/ref=ox_sc_saved_title_6?smid=A4YMN0FVY8LB2&psc=1 Is it okay to also do coil spacers to gain another inch or two? Would I need shock extenders...
  10. V

    Rear turn signals

    Hi all! I noticed only the top tail light flashes with the turn signal... Is there a way to wire the tail lights in a way so that both of them flash with the turn signals? Like splicing one of the wires of the top socket to the a wire in the socket below it? Thanks in advance!
  11. V

    Trans fluid change

    Which one is the supply line to the radiator? Could you please send a pic, if possible? I was probably going to use a gasket. I'll keep that flat filter seal thing in mind as well!
  12. V

    Trans fluid change

    Any help?
  13. V

    Trans fluid change

    Hi all! I want to change my fluid and filter. In other vehicles, I have used this method: 1. Drop pan and drain fluid 2. Replace filter 3. Put pan back on and replace fluid with the same amount that drained out 4. Pull return line to pan and, quart by quart, drain old fluid and replace with...
  14. V

    Help! Checked one spark plug...

    That seemed to do it. Thank you!
  15. V

    Help! Checked one spark plug...

    I'll give that a shot and report back. Hopefully that works. Thanks!
  16. V

    Help! Checked one spark plug...

    I took off the coils on the passengers side, checked one spark plug, saw it was fine and put it everything back. Now I have 4 codes! P0353, P0357, P0351 and P0355. All coils are seated correctly and the spark plug I put back was tightened down. What is happening?
  17. V

    Lift coil and spacer combo?

    Hi all! I have an '03 2wd, and I have the back lifted 3". I wanted to lift the front to match. Could I do 3" coils with 3" spacers to get 6" total? Thanks!
  18. V

    P0128

    Yes, I put a 180* in there, and thought the Superchips tune would cause the ECM to accept the 180* without throwing the code. It comes up every couple of weeks and I clear it with a scanner, but I'd like it gone for good...
  19. V

    P0128

    Hi all! I have been repeatedly getting a P0128 code. I have a 180* thermostat and I thought the Superchips 91 tune would take care of the code not appearing. Any way to turn the code off?
  20. V

    Y-Pipe replacement

    If I wanted to cut the stock y out and put in a more free flowing one, would I need a dual 2.25" to 3" or a 2.5" to 3"? Thanks!
  21. V

    WTB: Superchips Flashpaq 3865 w/trans pack

    Looking for an unmarried Superchips flashpaq 3865 w/trans pack for my '03 4.7. Let me know!
  22. V

    Belltech Rear Sway Bar Install

    Awesome! Thanks all! Hoping to get this installed tomorrow, along with some drilled and slotted rotors and an oil change.
  23. V

    Belltech Rear Sway Bar Install

    So, to clarify, install the self-tapping screws with the bracket on to the frame, with the end links perpendicular to the ground, when the truck is on the ground?
  24. V

    Belltech Rear Sway Bar Install

    Hi all! I am planning on installing my Belltech 5555 rear sway bar this weekend. I have been reading over the instructions a few times to familiarize myself with it. It implies that the end links should be perpendicular to the ground for optimal performance. Is this when the truck is jacked...
  25. V

    What tuner to get?

    Looking to get a tuner for my 2003 4.7 auto. I have read some good things about the superchips 3845. Any other suggestions?

Latest posts

Staff online

Members online

... and 16 more.
Total: 1,337 (members: 66, guests: 1,271)
Robots: 1,766

Forum statistics

Threads
195,612
Posts
2,872,531
Members
156,431
Latest member
5ccarter3

Share this page

Top