Search results

  1. K

    Engine shut down

    Was it seeming to turn over fine? Did the steering wheel lock or are you saying the tires locked up?
  2. K

    Comp 260. To cam or not to cam...

    The rods are diff lengths. Get 8 6.1 intakes and 8 6.1 exhaust pushrods while you are ordering.
  3. K

    Comp 260. To cam or not to cam...

    The aftermarket stall is cut and made with better internals. For the towing you do go with a 2600 stall and a bigger trans cooler.
  4. K

    Comp 260. To cam or not to cam...

    You can find C.A.R.B compliant headers. A comp 260 will be a nice drop in cam for what your looking for and get a Trinity CRM tuned and turn off the MDS system. If you leave it on they tend to sound funky. I ran a cam, intake and tune for years and you will be surprised how much better it works...
  5. K

    Wanting a bigger cam

    Yall will take some looking to find the 6.1 oil pumps like I mentioned before. They are currently on a nation wide backorder from Mopar.
  6. K

    Wanting a bigger cam

    If it was my truck buy a new timing chain set, 6.1 springs and rods. Cam wise you have been given some good info, its all in what you want your truck to be.
  7. K

    Wanting a bigger cam

    I would tell you to shy away from the comp springs and get yourself the 6.1 springs and 6.1 pushrods. The reason on the comp springs is they have been know to break, some as soon as start up. How many miles are on the truck? During a cam swap its a great move to upgrade the oil pump (6.1 pumps...
  8. K

    I got some new times.

    Humidity change later on?
  9. K

    I got some new times.

    Congrads on the new times. Show the full slip on the 15.0x slip so we can see what time that was ran far as temps at the track cooled off or if the motor did some. Trap speeds were pretty consistant through out. If you knocked out all 15.2x passes back to back you would have a good bracket truck...
  10. K

    Spectre CAI and spark plugs

    If you can't swing a new cone then get a filter wrap to try to help it out.
  11. K

    Spectre CAI and spark plugs

    Might wanna look into a better cone filter. The Spectre ones have been know to let junk past it.
  12. K

    overheating 07 5.7 after repairs

    Yep you need to "burp" the system
  13. K

    5.7 misfire but no codes

    Check your alt to see if it spins freely or test it to see if the power is jumping.
  14. K

    5.7 misfire but no codes

    There is something going on with your wiring, sounds like a ground or dead short now.
  15. K

    Running lean in bank 1

    Just didnt want you buying sensors for no reason.
  16. K

    white exhaust valves

    Then you should be fine just get the cooler tstat in to richen up the A/f
  17. K

    white exhaust valves

    Get a 180 in there asap to help fatten up the mix. Im not sure what Bully and Hypertec have for their timing on 93 tune and what they adjust on their fuel tables. I know with Diablo and Superchips your still in a safe zone with those mods. Pull a few plugs and see what they are looking like...
  18. K

    Running lean in bank 1

    The rear o2's do not effect running, they just say if the cats are working if you had them. The upstream o2's are the ones that effect running.
  19. K

    Running lean in bank 1

    If the cut outs are close enough to the up streams it will throw the code and the PCM will try to compensate. Your o2s are not damaged from running with out cats unless when you were doing the exhaust you beat on them or damaged a wire by cutting or laying against the header. I havent had cats...
  20. K

    5.7 misfire but no codes

    Then its just surging and not missing. That points to an air leak or vac now, check intake manifold bolts, tb gasket seated
  21. K

    Headers and exhaust question

    Then just the long tubes will be all you would need. The collectors on the headers are 3", do you have a cross over pipe to balance the tubes? If you do not add that in your exhaust as your doing it.
  22. K

    5.7 misfire but no codes

    Unplug the coil pack and pull the boot on that cylinder that will make sure that hole is cold. The coil pack does the ig spark and the second plug is a wasted spark for emmisions. If you have access to a temp gun you can check the manifold and look for the cold hole. If all are within 20-50* of...
  23. K

    5.7 misfire but no codes

    Is it a dead miss or just missing every once in awhile? Have y'all tried to identify which cylinder is the issue? Could be an unseated push rod, cam gear out of time by a tooth, coil pack not seated on the plug, cracked plug, injector not seated, injector harness at the back of the motor not...
  24. K

    All I wanted was a stroker

    Im with charonblk07 they should have checked the rod being seated correctly before jumping the gun. How many Hemi's has this machine shop your using done? These motors are simple to do but getting in a rush will bite you in the ass. Did yall not install new lifters? Any new motor esp when its a...
  25. K

    2003 QC Muffler Swap

    Glad your liking it. Hope the weather clears up so you can get to enjoy it on the open road more.
Top