RubberFrog
Senior Member
I bought these from a member on another forum a month or so ago. They were a little too short for my lift so I had to buy new 5/8 SS rod to lengthen them a bit. I finally got the rod in yesterday, cut it to the length I needed, and got them reassembled. It was a bit of a surprise this morning when I realized I had to drill out the lower control arm to accomodate the larger stud mount (thanks for the heads up...). A little cutting fluid and low rpms went right through it in a matter of minutes.
So here they are. What do you think?
So here they are. What do you think?