EVIC re-set

[donno21]

EVIC will not re-set after tpms was corrected Will not respond to selections by using owners manual. 2011 RAM 2500, 4wd, Cummins. HELP

 

[R.L.K.]

Try this .

Disconnect the + & - terminals from the Battery , next touch them together for about 10 seconds . This does a soft reset of multiple modules throughout the truck .
Leave both terminals disconnected for at least 30 minutes, over night if possible.

Hope this helps !

 

[Joji91]

Just drive it for a while. Mine took a day to read them again.

 

[donno21]

I assume both batteries must be disconnected?

 

[TonyMM]

I assume both batteries must be disconnected?

Both batteries? I for sure know where I have one near the engine. But where is the second batterie?

 

[Joji91]

Both batteries? I for sure know where I have one near the engine. But where is the second batterie?

I think he means both terminals of the battery.

 

[R.L.K.]

Both terminals on your Battery. To my knowledge, you have only one battery .
Hope this helps.

 

[R.L.K.]

I assume both batteries must be disconnected?

I'm not familiar with the 2500 diesel trucks , but if you have two batteries then I'd assume you have a Main battery that's connected to the PDC (Power Distribution Center ) aka fuse box .

This would be the battery to disconnect and touch the terminals together for a soft module reset .

If both batteries are connected to the PDC then yes perform this procedure on both batteries. Make sure all batteries terminals are disconnected prior to touching any terminals together .

Hope this helps , sorry for any confusion.

 

[donno21]

Yes, the Diesel has 2 batteries. Thanks, I'll try the disconnect trick.

 

[Joji91]

Let us know how it goes.

 

[donno21]

Sorry it took so long to reply, been busy. I disconnected batteries and touched the cables together as was suggested. I left them disconnected over night. I can scroll to "system setup" and that's it. Any more ideas? Thanks.

 

[donno21]

EVIC still won't re-set

 

[jwheeler]

There is no reset procedure for low tire pressure. It may take a couple miles of driving but if it still says the tires are low, they are low or there is a bad sensor.


Sent from my iPhone using Tapatalk

 

[donno21]

Tried the cable disconnect thing, even left them unhooked over night. Still wont come out of "select" mode. HELP!!!

 

[donno21]

I corrected the tire pressure and drove the truck, tire pressure light(s) went out The problem is the EVIC wont reset. (miles vs KM /mileage / miles to empty etc) I get as far as SELECT and that's it. Any thoughts?

 

[donno21]

The problem IS NOT with the tpms, it's fine. It's the EVIC will not come out of "select".

 

[R.L.K.]

Hmm , I wonder if there's a module for the evic ?
It may be part of the instrument cluster not sure .

 

[stimpy433]

Could be your steering wheel buttons are messed up, I know it's happened to others.... might be why you can't change your EVIC screen???