QA1 Shocks for Inez Hotrods 4/6 Drop Kit

[Avgas]

I am getting ready to install the Inez 4/6 kit on my '15 Reg cab, and want to order QA1 performance shocks for all four corners.

I have searched through a few threads but was unable to come up with the exact part number shocks.

Does any have the PNs for the QA1 shocks recommended for the 4/6 drop?

Thanks

 

[wink]

I'd try QA1 if no-one responds. Or if they can't help, maybe Stage6, there in Florida. They had some custom made for the Jeep SRT8's. That's what I've got on mine. Not sure about the RAM's though.

http://stage6motorsports.com/

wink

 

[Avgas]

I'd try QA1 if no-one responds. Or if they can't help, maybe Stage6, there in Florida. They had some custom made for the Jeep SRT8's. That's what I've got on mine. Not sure about the RAM's though.

http://stage6motorsports.com/

wink

Should I just tell QA1 the size of the drop and ask for the recommended shock?


I believe that with the Inez 4/6, the front suspension geometry stays the same, so I guess I would need the same shocks needed for stock height?


I will also send a message to Inez Hotrods

 

[wink]

My guess would be QA1 would need the specs for the shock you need. Not the amount of drop. Inex might be the best source, unless another member has been there and done it. That's all I can suggest...

Good luck!

wink

 

[Wild one]

Gary's Hemi I think is running the QA1's on his lowered truck,if he doesn't respond here,go over to Nadodge on Facebook and tag Gary Trail on there.Supposedly Viking has as good a shock as the QA1's that's double adjustable.

 

[WadXpress]

I thought I read in a thread that qa1 doesnt make shocks that match the specs you need for the 4/6 could be wrong though

 

[Quicksilver337]

I thought I read in a thread that qa1 doesnt make shocks that match the specs you need for the 4/6 could be wrong though

you are correct the QA1 shocks that have been recommended on here will not work for the Inez 4/6 setup. Remember the rear shocks are shorter than the ones that come with the Belltech 2/4 kit. You can get away with the factory front ...
There is a thread on here that talks about this let me see if i can find it....
Here you go...
http://www.ramforum.com/threads/shocks-for-lowering.99668/

http://www.ramforum.com/threads/inez-4-6-review.111306/page-4


I posted on the thread about the QA1 shocks not functioning with the Inez 4/6

2/4 lowering only
QA1 Shocks

Front: TS514
Rear: TS905

no modifications required
--------------------------------
If using the Inez 4/6 or 5/7 lowering kit shorter shocks need to be used. The rear QA1 shocks don't work properly.

Rear: KYB KG54308 or Pro Comp ES9000 Shocks 919500

 

[Avgas]

Thanks for the info guys