Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Got my front camera up and running yesterday using m2mods harness and Alfaobd.
It took over 24 hours for it to finally show up on my screen. I also, after to years figured out that you can drag/drop/change icons on the menu bar on the 8.4.
COOLINT Vehicle Backup Camera, CT-106S Mini 360 Degree
COOLINT Vehicle Backup Camera, CT-106S Mini 360 Degree Rotatable Car Multifunction Backup Rear View Camera with Switcher
I have a couple pictures of the connector but not of the pins in the connector. Memory not good enough to remember which ones to point out. Going to be removing my front seats on Thursday if the weather holds out to finish my keyless go install. Will post some then if no one beats me to it.Anyone have a picture of the proper pin locations? Not a diagram, I've got 1/2 dozen of those, looking for an actual picture.
-K
For pins 24, 25 right. Lay new see of I have anything...Anyone have a picture of the proper pin locations? Not a diagram, I've got 1/2 dozen of those, looking for an actual picture.
-K
@DeereGuy Where do you have pin 26 running to?
Maybe off topic here, but is there a way to have a cargo and a front camera, with the factory reverse camera? I’d love to have all three for mine.
Yes, sorry momentary lapse. The cargo cam is differentIf you are hooking up a factory camera they require 3 wires. The signal, return, and shield.
I see. Ok, thanks for the info!I believe the only way to do that is with an add-on device like the LockPick. Despite the fact that the radio connector in our trucks has pins marked for a dedicated front camera and the BCM has options for it that can be turned on, the radio firmware does not have the ability to display the signal from it. Both the pins and BCM options are for other vehicles that use the same parts.
-K