Redheadhunter21
Senior Member
So I bought a set of flush mount LED lights to mount in the bumper as I have seen a couple trucks with them installed. Got the lights in hand and figured out the curve of the bumper is going to cause a gap at the bottom of the lights and the bumper.
Have y'all that have installed flush mounts had the same problem, or do they make some that the plate is slightly curved? Figured at worst beat them into submission but I think the bumper will bend first.
lights are similar to these
Have y'all that have installed flush mounts had the same problem, or do they make some that the plate is slightly curved? Figured at worst beat them into submission but I think the bumper will bend first.
lights are similar to these