crazykid1994
Senior Member
I have my harness. It’s 8awg wire but I need to swap the 50 amp fuse from the pentastar fan out for a 60 amp. Also remember it’s not run off a relay. That is the pwm control. It uses soft on with ramp up instead of a straight on or off setting like the older v6 fan. Remember that’s why I installed my fan controller to begin with on my v6 fan. My current v6 fan and controller run around 20% when fully warm and cycle higher as needed or full speed for the ac and is all solid state hardware so no relays to burn. I hated using a relay that’s only on/off which is why I like this. I think it’s supposed run 10% when above a certain temp and ramp up as needed. My module also reads ac line pressure from the canbus so it can monitor and adjust fan speed to the ac as well.That's gonna take at least 10G or maybe even 8G wiring and at least a 50 amp relay to run it,i'd think Khris.That suckers gonna want alot of power at fan kick in,if it's 600 watts