Recent content by 17RedSled
-
Mystery Clunk, Help!!
It isn’t touching the frame, it appears that the upper flat plate above the bushing is touching the sway bar itself. Sent from my iPhone using Tapatalk -
Mystery Clunk, Help!!
I just did tightened it some and the noise isn’t as common while driving but it’s still there… I’m guessing it’s time for a replacement link? Sent from my iPhone using Tapatalk -
Mystery Clunk, Help!!
That is correct I had just got home from driving around. But, the sound is very prominent at the 0:08-0:12 marks. Sent from my iPhone using Tapatalk -
Mystery Clunk, Help!!
Hey everyone, not sure if I posted in the wrong place so I apologize in advance if I have…. So, I’ve got a 2016 Ram 1500 Crew Cab 4x4 with 80k Miles. In the past 5,000 miles I’ve added a 2.5 inch Rough Country leveling spacer kit. Just before adding the spacer kit I began hearing a very random... -
Bench Seat Setup For Sale or Trade
Swapped to a full console, no longer need these parts. All parts in good condition unless mentioned otherwise. Bench seat does not have the lower opening portion. Includes media hub, wiring, all ducts and panels. The drawer latches fine and stays shut, but seems to have a bit of an issue lining... -
WTB Center Stack for Console Setup
Please delete this post, between the scammers and thread jackers I had to find one elsewhere. Sent from my iPhone using Tapatalk -
WTB Center Stack for Console Setup
Do you still have it?? Sent from my iPhone using Tapatalk -
Rear park assist Setup
Sending PM Sent from my iPhone using Tapatalk -
Shifter Lever Upgrade
Hey everyone, I was looking to upgrade my shifter lever to the chrome limited style. Anyone happen to know the part number? Sent from my iPhone using Tapatalk -
How to Add Overhead Console
Hey guys I’ve installed an overhead console about a year ago and I never managed to grab the harness which contained the wiring for the light that illuminates the console area. I’ve referenced which light I’m referring to in this photograph. Does anyone know where I can snag power for this...- 17RedSled
- Post #446
- Forum: 4th Gen DIY
-
How To: 13-14 premium cluster upgrade
Hey everyone, I completed this swap about a year ago. Only issue I’m seeming to have is when I enter the truck after leaving it off for a while, it always default boots to the engine temperature, oil pressure etc. menu. If I turn the truck off and come back to it within the hour it will boot...- 17RedSled
- Post #915
- Forum: 4th Gen DIY
-
WTB Center Stack for Console Setup
Searching for a center stack for a console setup. 13+ thank you Sent from my iPhone using Tapatalk -
WTB Center Console Lid Gray
Searching for a Gray Console Lid 2013+ thanks Sent from my iPhone using Tapatalk -
2016 Tradesman remote start help.
Hey man. I just did this to my 2016 Tradesman. No new antenna module needed. To begin, check your upper radiator support to see if the harness to support the hood latch is there. If so, you can purchase the hood latch, the key overlays for your tip key and program the info necessary via ALFAOBD...- 17RedSled
- Post #2
- Forum: Audio & Electronics
-
How to add remote start to 2017 Ram
For whoever just asked for confirmation if it works on 13+ rams just as advised it worked for me yesterday. Grounded pin 11, changed the setting in Alfa to 500-500, got the overlay for my key and it was a go for me... 2016 1500 5.7 Tradesman Sent from my iPhone using Tapatalk- 17RedSled
- Post #425
- Forum: 4th Gen DIY
Members online
- 3pedals
- Randy Grant
- stevenP
- Tom Hosler
- Ken226
- Jucamvil
- gevans58
- Thebusdriver
- logsplitter234
- aszumilo
- RamInfo
- zachgti
- manuel gonzalez
- Bricvic
- skuppy069
- Bill Z
- Chukbacca
- terb
- thtsaustin
- timbo6723
- Ramsay
- smithabs1963
- Steve Cloud
- Marshall
- mtofell
- deathbyburito
- Mike70
- KalboKalbs
- Mopar no car
- Shawn Burns
- Antonio__C
- stony
- Bobwilla123
- Camille
- CDN911E
- 1lost1
- ithurtz
- Jbaandm
- mrack
- Drifter667
- Dark Knight 500
- masff
- Atcer2018
- Dyeelitt
- Gr8g
- Ruud
- CRS1968
- davjorden
- waxsmasher
- vhmike73