I think the only way you could accomplish this would be to put spring compressors on it while it’s on the truck. Doesn’t seem that safe but to me that seems to be the only way you could do it to take the load off that retaining ring.
Sent from my iPhone using Tapatalk
There is a steering extension that they put on. Make sure it is tight. Only thing I can think of. Maybe someone else will have another idea.
Sent from my iPhone using Tapatalk
I was going to suggest checking the battery connection maybe wasn’t tight enough and after driving loosened up and it was running off the alternator so wouldn’t notice until you went to start again.
Sent from my iPhone using Tapatalk
I have a 4” lift with bils at 1.4 20x12 with 35x13.5 tires. I rub on the inside bottom of the front bumper on drivers side only. If I were to trim off about an inch off the inside edge of bumper it would stop. However I’m getting the go rhino front bumper so I’m not going to bother trimming...
I had this too. There is a little hole that the light tab snaps into on either side of the bracket and mine were worn out. I put a zip strip around the side of the bracket through the hole and and put the light tab back into the hole. It tightened it up. I have since upgraded to the Morimoto fog...
Yes they have closed batteries. You have to replace the sensor when it goes bad. A local tire shop should be able to scan it for you and tell you the battery life or if it needs to be replaced.
Sent from my iPhone using Tapatalk
Yes if the bore on the new wheels is bigger than the job because you will never get the wheels center on the hub. They will always sit toward the bottom when you put them wheels on and even that little bit can throw off balance. A more aggressive tire will almost always have a little vibration...
No and to be honest when I looked at them in the boxes I didn’t notice either. It wasn’t until they were mounted and in the sunlight that I really noticed.
Sent from my iPhone using Tapatalk
Unfortunately after having the wheels mounted only one is the right color which is the top pic. The other 3 are the bottom pic color which is a little too cranberry ish for me so the wheels will be coming off and going back to the powder coater. I couldn’t really notice it until they were...
Been doing a lot of COVID shopping. Just posting an update on my truck build.
New Ramair hood and new morimoto projector fog lights
New go rhino rear bumper with rigid flush mount lights
And wheels powder coated getting installed tomorrow.
Sent from my iPhone using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.