Recent content by 67gto3spd
-
Bilstein 5100 part#
I cant seem to search this out. Thinking of putting these on the rear of my'15 rcsb with 2/4 drop. Anybody know the part # off hand? Have a stock type shock on now and hoping for a little smoother ride. Should I expect this from the bilsteins? -
4th Gen Official Timeslip/Discussion Thread
First time at track with this truck. 2015 rcsb hemi Vararam,. Generic flowmaster type muffler. Best run was with traction control off, manual shifting. Pretty happy- 67gto3spd
- Post #789
- Forum: Engine & Performance
-
What did you do with your 4th Gen this week?
Wrapped my mirrors in vinyl. Bought a cheap heat gun and went at it . Very pleased for my first time. Avery sw 900-803-m gloss silver metallic is a very close match for Ram bright silver- 67gto3spd
- Post #26,839
- Forum: General Discussions
-
Weird vibration/Shudder
I typically run around 36 or 37. Definitely worth exploring. Thanks -
Weird vibration/Shudder
I could have written this post. Mine does the same thing. RCSB 2wd. I was hoping it might be the lower end tires. Going back closer to stock from a bell tech 2/4 kit lessened the vibration. Softer shocks seemed to help a little too but it's still there. Only complaint I have about my truck. -
Belltech questions from newb
Appreciate the reply. I just thought a truly progressive rate spring wouldn't have the top leaves pressed together like that . And yes I do have a lot of bounce . Trying to decide if the Bilsteins would be that much of an improvement. Hadn't thought of air bags but I have a set on my GTO that... -
Belltech questions from newb
Just bought a 2015 Ram rcsb. It has a 2/4 belltech kit already installed. Wanted to confirm that the springs look like they are supposed to. Hadn't seen any before with the top coils completely compressed together. Also I have a bumpstop gap of 1/2 an inch in the rear. Should they be cut? . Do...
