Recent content by atreides
-
A
Loss of power steering
From what the dealer said, it’s a new “kit” that includes manifolds with updated hardware. I believe the manifolds are the same, part numbers for the manifolds were: 68591585aa, 68591586aa. Apparently since they’ve done manifold and stud replacements with the new hardware, they haven’t seen any...- atreides
- Post #35
- Forum: General Discussions
-
A
Loss of power steering
Update on my power steering issue. Took it to my local RAM dealer. The electric power steering rack was definitely bad. The new rack resolved most of the issue but the steering still felt notchy and stiff. There were random points of resistance throughout the steering travel, it alternated...- atreides
- Post #33
- Forum: General Discussions
-
A
Loss of power steering
Getting my EPS replaced at the dealer right now (thank you Carmax extended warranty). Looks like it’s going to take a couple weeks for the dealer to get the EPS unit.- atreides
- Post #31
- Forum: General Discussions
-
A
Can anyone identify this leaking hole near the ECU please?
Fast replies, thank you all. So it actually is the AC, nice. There’s no other fluid leaks and it’s been around 80F and 50% humidity out here and the thing still drips more water than my Sequoia with dual ACs did. The water being hot is what concerned me as well, it’s not coolant hot but it’s...- atreides
- Post #5
- Forum: General Discussions
-
A
Can anyone identify this leaking hole near the ECU please?
I’m getting a lot of hot water dripping out of this hole near the ECU. Thought it was condensation but it seems excessive for AC condensation. It’s clear, hot, and odorless. Should there be a hose attached to this thing? It’s in a difficult spot to take pictures of. It’s circled in red in each...- atreides
- Thread
- Replies: 5
- Forum: General Discussions
-
A
axle help?
Haha it happens to the best of us. I read it like 8 times just to be sure lol. -
A
axle help?
Nothing there states if the struts are extended struts or not. -
A
axle help?
OP did not mention lifted struts so 1.5” spacers shouldn’t be an issue here. I had my truck on 3” spacers without brackets for almost a year and it was indeed not ideal as I already mentioned. With blown factory shocks and struts it rode like garbage actually. -
A
axle help?
They’re not ideal but a 1.5 inch strut spacer should not be causing the axles to bind. I had 3 inch spacers without binding out the axles. Popping the axle back in was the fix and removing the spacers likely had nothing to do with it. The only damage that may have occurred would be to the... -
A
Body Lift install question
I have the 3” PA kit as well. No issues here either with ditching the fan shroud. -
A
Adding to suspension lift?
You can get another inch or two with full length coilovers in the front and taller springs in the rear. This looks like Florida Man's lift kit of choice. -
A
Readylift and body lift
I don't have experience with Readylift specifically, but I did have a 3'' inch spacer lift with a 3'' body lift using stock struts and shocks. My truck did not ride well, even on the street, due to the front strut and rear coil spacers forcing the suspension to ride way too high in its travel... -
A
Will 33x12.5's fit on a stock 17x7 rim?
It depends on the specific tire make and model. Look up the spec sheet (or post the tire and we can look it up), it will tell you what the min and max rim width is for that tire. I’m going to guess the 12.5 tire is too wide. BFG K02 in 33x12.5 for example list a rim width range of 8.5-11”. -
A
8.4 Uconnect network connection always shows as disconnected (circle with line through it)
Got it thank you. Did some reading on the 4G adapters and people are having a ton of issues with them. Sounds like too much of a headache just to be able to send GPS coordinates from my phone to the head unit. :/- atreides
- Post #3
- Forum: Audio & Electronics
