Recent content by AustinsRam1500

  1. A

    DIY: 2013-2017 RA3/RA4 8.4" Radio Upgrade/HVAC Conversion

    Hey man I’m really hoping you can help me out with this. What happened was I was helping my friend change his small screen to the 8.4. We bought a radio and a hvac bezel and the hvac module from a local auto wrecker. I built him the same conversion harness that I built for my 2014 ram 1500 st...
  2. A

    How To Add Heated/Ventelated seats and Heated Wheel to Express/Tradesman

    I couldn’t figure it out so I just gave up and focused on upgrading to the 8.4 and new HVAC. I picked up a screen at the scrap yard and installed it. I used the screen for about 2-3 days with the old HVAC as I was waiting for parts to make the HVAC conversion harness. I gave the heated/vented...
  3. A

    How To Add Heated/Ventelated seats and Heated Wheel to Express/Tradesman

    I'm going to check all the wiring again and scan it again tomorrow. I've been tracing my wires by hand but I think I'm just going to go ahead and purchase a toner and wand and make sure everything is correct.
  4. A

    How To Add Heated/Ventelated seats and Heated Wheel to Express/Tradesman

    I took the switch panel out of a 2018 and put into my 2014 which fits fine and traction/tow works. And yeah I understand there's only so much you can do without seeing it. Do you know any places that would specialize in these things. I would bring to dealer but I don't think they could do much...
  5. A

    How To Add Heated/Ventelated seats and Heated Wheel to Express/Tradesman

    Another thing I noticed is when I click on drivers cooling it starts at 2 lights then immediately goes to 1 light. If I click the passenger cooling button. It starts at 2 lights and stays.
  6. A

    How To Add Heated/Ventelated seats and Heated Wheel to Express/Tradesman

    Just restarted my truck and tried vented seats and I heard the click and heard the fans turn on for the cooling seats. 7-8 seconds later button and fans shut off.
  7. A

    How To Add Heated/Ventelated seats and Heated Wheel to Express/Tradesman

    On first startup of the truck, I hear a click in the module when I press a hard button, 7-8 seconds later I hear another click and button goes off. If I click the button again then I don't hear any click and button goes off after 2 seconds. I have to restart my truck to hear the click again.
  8. A

    How To Add Heated/Ventelated seats and Heated Wheel to Express/Tradesman

    I checked that and it looked fine. I think if I hooked it up wrong then I wouldn't be able to connect to the heated seat module on alfaobd right? So maybe the issue is not the can wiring. Could it be because I have 2018 seats/module or because I don't have the 8.4 screen? I have no idea what to...
  9. A

    How To Add Heated/Ventelated seats and Heated Wheel to Express/Tradesman

    I did a full check of all my wiring today, traced everything and looked for any shorts but nothing. That was a mistype, I meant yellow connector. I cleared codes because I noticed I wired the heating steering wheel wrong by swapping the 2 wires. Now I'm only getting one code and it's U0147. The...
  10. A

    How To Add Heated/Ventelated seats and Heated Wheel to Express/Tradesman

    Yeah so my wires are correct. I ran from the PDC to the driver and passenger power connectors. Also from the PDC to the two P/Y wires at gray connector on driver side. I ran 4 wires to under the steering wheel. 2 going to the obd port and 2 going to where the heated wheel terminates. I don’t...
  11. A

    How To Add Heated/Ventelated seats and Heated Wheel to Express/Tradesman

    Okay so I hooked everything up for heated seats but when I press any of the hard buttons the light turns on for 2 seconds and then turns off. I’m getting a code from heating module saying right front heat sensor. When hooking up the wiring you said to run 5 wires in between both seats. 1 wire...
  12. A

    2014 Ram 1500 Express to Sport Conversion

    Okay I’m pretty confident in wiring this up. Now for the steering wheel, I want to get the gear up and down button working instead of the column shifter button. I was comparing the wiring behind the steering wheel with my old one and new one and it looks like these Red and GR/WT wire are added...
  13. A

    2014 Ram 1500 Express to Sport Conversion

    I think I’m going to go ahead with making my own harness because I can’t afford all those harnesses at the moment. Maybe in the future I’ll rip it out and put in the clean one from m2mods. Do you know the part number for the pins needed for the PDC and do you mind sending me the link to that...
  14. A

    2014 Ram 1500 Express to Sport Conversion

    I think I’m going to go ahead with making my own harness because I can’t afford all those harnesses at the moment. Maybe in the future I’ll rip it out and put in the clean one from m2mods. Do you know the part number for the pins needed for the PDC and do you mind sending me the link to that...
  15. A

    2014 Ram 1500 Express to Sport Conversion

    Okay so I have AlfaOBD for enabling the codes and I also just bought a case of wiring so I can make harnesses. I will probably have to buy M2mods radio and HVAC conversion harness but for the steering wheel and seats, can’t I just make my own harness? I was able to wire my power seats but they...
See more

Latest posts

Staff online

Members online

... and 18 more.
Total: 1,445 (members: 68, guests: 1,377)
Robots: 1,955

Forum statistics

Threads
195,596
Posts
2,872,325
Members
156,401
Latest member
jesmich

Share this page

Top