Recent content by Block

  1. B

    Dead instrument cluster, NO BUS

    I was able to pull a code with my DiabloSport tuner... U0155 - lost communication with instrument panel cluster (IPC) control module Can anyone point me to where this thing is located?
  2. B

    Dead instrument cluster, NO BUS

    My cluster too a dump on me today in my '05 2500 hemi... As I was pulling out of my driveway, all the gauges fell to zero, all the idiot lights came on and now I don't have any brake/parking lights, turn signals or horn. The odometer reads the correct mileage when you first open the door...
  3. B

    What did you do to your Gen3 today?

    Wasn't today, but she got some new rubbers ahead of the blizzard last Thursday... 285/70 Fun Country's. Absolutely love 'em! Just need to pull off the side steps and repaint them and I'm done for a while.
  4. B

    Mileage on your 3rd Gen.?

    Rolled 131,000 yesterday. Runs like a champ!
  5. B

    New Kenwood deck, very little sound.

    PRAISE JEBUS! I am ecstatic to report the problem has been solved. Turns out I needed the basic 70-6502 harness after all. I asked for help from the guys over at the12volt.com (fantastic resource btw) and one of the guys suggested... I wired everything except the mute and bam!, everything...
  6. B

    New Kenwood deck, very little sound.

    Can I just run a wire from the Ignition 12v wire off the new deck and tie it into the power for the cig lighter? I believe that's a key on 12v source.
  7. B

    New Kenwood deck, very little sound.

    I'm about to cry. lol With the XSVI harness, now I have nothing on the deck, no power. There isn't a red wire coming out of the female connector that plugs into the male factory connector in the dash. That's the only difference between the 6502/CHTO harnesses and the XSVI. I think that's the...
  8. B

    New Kenwood deck, very little sound.

    Dude, you are the man. Just ordered the XSVI harness from Amazon, should be here Monday. I'll let you know how it works out. Fingers crossed!
  9. B

    New Kenwood deck, very little sound.

    Alright guys, I tried a few things the past couple days. I threw in the new kicker 6x9's in the front doors and tried the new deck with the CHTO-02 interface and got the same thing, the deck works but very little volume out for the speakers. I decided to try the 6502 harness again just to...
  10. B

    New Kenwood deck, very little sound.

    Thanks guys. I'm installing new Kicker speakers in the doors as well, so I think I'm just going to run new wire and be done with it. I'm not really all that concerned with the 3 in the dash.
  11. B

    New Kenwood deck, very little sound.

    Can either of you tell me where the factory amp on an '05 is located? I've looked behind the glovebox and don't see anything.
  12. B

    New Kenwood deck, very little sound.

    I saw that, was really hoping to avoid having to go that route. Mine works, the deck works fine, I just get very little volume out of the speakers. I've tried that and it makes no difference. I even took the box back to where I bought it and swapped it for another one and still have the...
  13. B

    New Kenwood deck, very little sound.

    Anyone? This is driving me nuts.
  14. B

    New Kenwood deck, very little sound.

    I'm trying to install a Kenwood deck in my '05 2500. I've got the CHTO-02 interface for the stock Infinity system. When hooked up, everything on the deck works fine, but I have to turn volume knob all the way up to hear anything out of the speakers. I've triple checked all the wiring and...
  15. B

    off road edition 2nd gen

    My 2000 ORE is a 5.2 and yes, it came with a factory trans cooler.
Top