Recent content by Canadian Mopar

  1. Canadian Mopar

    5th Gen Seats into a 4th Gen?

    Yes, they still have the same cab so alot can be interchanged and will physically fit. The electronics is where you'll possibly run into problems. As far as your question, seats and door panels are an easy swap, dash and center console would be a different story.
  2. Canadian Mopar

    5th Gen 8.4 UAV Radio in a 4th Gen (And Possible Surround View)

    wow, that's awesome that you got the dash to work. Assuming just lots of custom wiring/harness' to make it work?
  3. Canadian Mopar

    Moe's Performance

    Ya been thinking about the same thing. Received half my order but still haven't been able to get in contact and haven't heard anything about the other half of my order. I'm not in a huge rush, and understand the situation, but definitely some kind of response would be nice.
  4. Canadian Mopar

    Additional UAQ/UAS Update Files 28.3/30.24/34.2

    What all settings did you change in Alfa? I updated to 39.5 on my UAQ the other day and performance pages is there, but when I go into it, it says that the performance pages are unavailable at this time and offroad pages have yet to show up yet.
  5. Canadian Mopar

    How To: Add Factory Keyless Enter N Go

    Even with the old fob ignition it should be smart start, like what you're talking about on your other vehicles, but perhaps because your truck is a manual they don't have that enabled. Only thing I could see.
  6. Canadian Mopar

    Power steering reservoir bracket?

    So I just put my engine back in my truck after a rebuild (6.4L BGE) and I have this one bracket left over, I obviously forgot to take a picture or label where it came from but if I look it up in the parts listing it is listed as a power steering reservoir bracket, I'm not entirely sure if that's...
  7. Canadian Mopar

    2019 HD Tail lights in a 4th gen

    Assuming you have to have the '20+ BSM modules for that to work?
  8. Canadian Mopar

    6.4L Cam Experiences / Testimonials

    I have my 6.4L out of my 2500 Ram ATM, had a bad / weak lifter that was causing all kinds of racket. Anyways so just in the process of collecting parts and I I'm looking at massaging this thing a little while I got it out. Looking at doing a MDS delete and cam swap (have headers and a couple...
  9. Canadian Mopar

    American Racing Headers at Got Exhaust

    Do you still carry these? Interested in a set of long tubes for my 6.4L.
  10. Canadian Mopar

    6.4L HEMI issues, stumped.

    Awesome, thanks, always reassuring that I'm thinking along the right through process here and not chasing a problem that was only in my head haha. But ya that lifter does feel pretty terrible, I can't see how it would have been able to operate correctly like it is. It would also make sense as...
  11. Canadian Mopar

    6.4L HEMI issues, stumped.

    Hey guys thanks for the insight and guidance here, I went back and double checked some stuff today and think I may have found the problem. So on this lifter (left) it was actually stuck in the "down" position I guess you'd say, I was able to get it to partly come back up, but as you can see...
  12. Canadian Mopar

    6.4L HEMI issues, stumped.

    No, I did not unfortunately, from all I had read with the cam and lifter issues on these HEMIs and the combo of rough idle, CEL, and very noisy top end I figured that was the problem.
  13. Canadian Mopar

    6.4L HEMI issues, stumped.

    I did a quick visual on the springs, push rods, and value seats and didn't see anything unusual but I'll take a closer look, thanks!
  14. Canadian Mopar

    6.4L HEMI issues, stumped.

    Yes I cleared the CEL after that incident, but the rough idle and noisy top end were on and off. I didn't drive it a whole bunch after that but one time I'd start it and it'd be back to normal, and the next, or sometimes 5 minutes later it'd be back, or vice vera, almost like one of the lifters...
  15. Canadian Mopar

    6.4L HEMI issues, stumped.

    It was around freezing, so not that cold, especially for up here. I had been a fair way into a road trip as well so everything should have been well up to temp. I will say as well that when my CEL light came on I was passing on the highway and had my sock in it with a trailer behind so it was...
See more

Latest posts

Members online

Total: 403 (members: 8, guests: 395)
Robots: 1,082

Forum statistics

Threads
195,469
Posts
2,870,596
Members
156,177
Latest member
joeyoliver45

Share this page

Top