Recent content by cityredneck
-
Best LED fog lights?
i'm using rigid sae fog pods (50481) and flood pods (202113) in place of the factory fog lights edited to provide the model numbers and change from sae driving to flood- cityredneck
- Post #26
- Forum: Exterior
-
Remflex 6022 gasket install question (no heat shield on it like stock gasket)
when i replaced my factory manifolds with shorty kooks headers (had them ceramic coated) i used the remflex 6022 gasket. got rid of the heat shield. i've had no issues and the trans temp actually went down some (15-30 degrees) if i remember right.- cityredneck
- Post #4
- Forum: Engine & Performance
-
Bilstein 6112 owners, what setting did you go with?
i was running 275/60/20s without the lift, no rubbing, no issues. i know the 65s will be a hair bigger, but shouldnt need a lift.- cityredneck
- Post #16
- Forum: Lifted
-
Bilstein 6112 owners, what setting did you go with?
i'm at 2.8 setting on the 6112s, zone upper arms, and 3/4 spacer in the rear with 5160s shock. the ride is awesome, so much better than stock. i'm running 275/60/20s bfg ko2. so far i've had no issues with my cv axles up front.- cityredneck
- Post #14
- Forum: Lifted
-
Power Distribution Box
if you can provide a pic that might help- cityredneck
- Post #2
- Forum: General Discussions
-
-
Rear axle noise after service 2021 Warlock
at my 30k mile service i also had them replace the rear diff fluid. a few day later i noticed noise from the rear axle. went back to the dealership and one of the techs took a ride and heard the noise, he said that it appears that the limited slip modifier wasnt added when they replaced the diff...- cityredneck
- Post #10
- Forum: General Discussions
-
Soft suspension on a 4x4
yes, i used a zone upper control arms if i remember correctly. my truck is leveled. if i would do it again, i think i would lift the front 2.1 inches instead of 2.8. but i do have a ranchhand bull nose and hopefully this summer ill be adding a kleinn onboard air/horm setup. so i got a little...- cityredneck
- Post #19
- Forum: General Discussions
-
Soft suspension on a 4x4
the front 6112s i got came with bilstien springs and i used those. i reused the factory rear coil springs just added a 3/4 inch lift and the 5160s. i did the helwig about a year or two before i did the struts and shocks. oh, i did set the front 6112s to the 2.8 inch lift height. totally...- cityredneck
- Post #15
- Forum: General Discussions
-
Soft suspension on a 4x4
i did the helwig and used the middle hole. was decent, but when i upgraded to bilstein 6112 front and 5160 rear, still with the helwig set to middle hole and the ride is great, its stiff, but also soft when hitting a big bump/hole. i've got 20" wheel and bfg k02s d-rated i think, i know thyre...- cityredneck
- Post #13
- Forum: General Discussions
-
Magnaflow 18"?
ive got a 2017 cc 5.7 with a generic magnaflow 18, it does have some drone, but moreso when the mds comes on it sound odd, so now i drive with tow/haul and d+8 turned on all the time- cityredneck
- Post #11
- Forum: Engine & Performance
-
Need advice on control arms? Pinion Angle
have you taken it to an alignment shop to get it aligned? would have a better chance of seeing how far out it is and the shop might know how to adjust/correct- cityredneck
- Post #4
- Forum: General Discussions
-
Rough Country Exhaust (96009)
sorry, i havent. i had a muffler shop install a magnaflo 18 inch muffler inplace of the stock. i love the way it sounds, i cant stay off the go pedal lol- cityredneck
- Post #3
- Forum: Engine & Performance
-
Truck stuck in park, Red lightning bolt, abs light, 4wd service light. Help!
ouch, but at least it's fixed- cityredneck
- Post #14
- Forum: General Discussions
-
Yellow LED Fog Lights?
i'm using rigid sae/dot fog pods and rigid sae/dot driving pods both with yellow lenses over them. the night pick is with them in the factory bumper.- cityredneck
- Post #20
- Forum: General Discussions
