Just wondering what everyone picked to ground? Obviously power from alt to power on battery, negative on battery to a ground point on frame.. but what about the alt ground? Seems the alternator inls part of the engine case almost.. i would think its pretty well grounded there..
I got it to fit under the carpet in the front beside the plastic raceway and had to go through the raceway in the back. There was enough room as one of the channels is empty in the back seat area. But now my amp rack is too big.. going to have to rethink this.
Mine said "press to install update", on the screen everytime i shut my truck off.. finally pressed ok and it installed.. this is definitely new though as it never happened this way on my last 2 rams with the 8.4
Yes u can tap sub wires for signal but dosen't come without its own problems. Theres a rubber boot through the firewall above your pedals that gets u in. Under kickplates will work depending on what size wire your running. For 1 sub you should be fine. Problem with the sub signal is it rolls off...
I think i will run it under the truck, supposedly there is a knock out already behind the rear driver seat for the etorque cables. My board is only 20x24.. should b good.. just waiting for warmer weather.
Like the title says, im getting ready to start my install and am wondering how people are running the 1/0 cables? Ive had 3 previous rams and always have run under the door kick plates, but that was always #4 and it was tight. Now that im running 1/0 and installing 2 amps/dsp i think it may be...
Thank you.... my buddy just bought a classic and we installed all my old 2017 ram sport parts that i pulled off b4 i traded for a 5TH GEN. Classics are 4th gens.. ram had way to may 4th gen parts kicking around, so instead of stockpiling old parts the slapped together 2019 4th gen classics and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.