Recent content by colomountains

  1. C

    2020 Limited Rear Bumper

    Benny, Thank you so much!! Good thing that I contacted you about this! I was way off on the parts! Sincerely, -ColoMountains
  2. C

    2020 Limited Rear Bumper

    Hi Benny, I have a 2020 Limited Eco Diesel with dual exhaust bumper, which I just need to replace the bumper (steel part) along with the inner rear left valance, sensor, and wiring since the wire got ripped off. I think I got all the parts, I just need to verify that this is the correct bumper...
  3. C

    Oil catch can for 2020

    Quick question does the 2020 EcoDiesel motor have an oil catch can from the factory? I have found the following oil separator Engine Oil Separator - Mopar (68147525AA)...
  4. C

    2020 EcoDiesel Limited 4x4 intermittent remote start issue

    Thanks for the replies, I took the truck back to the dealer and asked they check the starter and there were no problems. The next step is the load on the battery. I also try to keep the tank at least half most of the time.
  5. C

    2020 EcoDiesel Limited 4x4 intermittent remote start issue

    Thanks, I will talk to the dealer and have the starter replace, since I am still under warranty.
  6. C

    2020 EcoDiesel Limited 4x4 intermittent remote start issue

    Hello, I need your help, I have taken my 2020 EcoDiesel Limited 4x4 to the dealer twice to deal with a remote start issue, when it is very cold and the truck is parked at an incline at my house of about 2% grade. The first time that I took it, a control module was replaced in the cabin and the...
  7. C

    2021 Eco Diesel DEF Question

    I used to go to Wally World for my DEF, but sometimes the shelves were bare!!! I also looked for the freshest date on the shelf, but it got old quickly. So I have been going to truck stops to get the freshest DEF! I usually don't let it get below 1/2. I have also found that the price of the DEF...
  8. C

    Workaround to instal oem bed divider

    I am encountering the same issue as well, and I saw that post also; but I cannot find it. For what I recall, he ended up notching the divider rails to make this work. I have been looking for the shorter clamps as well, but I don't see nothing that will work.
Top