Crooks1130
Reaction score
42

Latest activity Postings About

    • Crooks1130
      Crooks1130 replied to the thread Cam/Lifters Update.
      If you do it by hand, just find a way to jam it from turning and it goes on pretty east
    • Crooks1130
      Crooks1130 replied to the thread Cam/Lifters Update.
      I’ve done it by hand and torqued to spec before and have also don’t the impact and called it good, never seen an issue with either. No...
    • Crooks1130
      Crooks1130 replied to the thread Dipstick Mounting.
      I honestly can’t remember on factory manifolds, but on my headers I fished the dipstick through them and bent it a little to mount to...
    • Crooks1130
      Crooks1130 replied to the thread update of 5.7 engine rebuild.
      If this were the case, the cam would be ruined also. @CrasherAsher I’m assuming the top end is all good? Also I’m curious how much you...
    • Crooks1130
      Crooks1130 replied to the thread update of 5.7 engine rebuild.
      Yes we should avoid excessive idling, but during a break in the ring seat process needs different ranges of RPM. Not sitting for 5-10...
    • Crooks1130
      Crooks1130 replied to the thread update of 5.7 engine rebuild.
      • CAE9B7C6-37E5-4F15-94C4-8927FB84C288.png
      • 397CF89C-EC50-4FD0-90AB-FCBD058B91B7.png
    • Crooks1130
      Crooks1130 replied to the thread update of 5.7 engine rebuild.
      I’m not sure if you could call oil pump being the issue because the sump tube was full of debris and the debris made it to the top of...
    • Crooks1130
      Crooks1130 replied to the thread update of 5.7 engine rebuild.
      Now I will say it is possible for something I’m the top end to fail and send metal particles down into the oil then pumped back into the...
    • Crooks1130
      Crooks1130 replied to the thread update of 5.7 engine rebuild.
      Ok you said they did a full rebuild from top to bottom, so new rings, main bearings, rod bearings, honed the piston bores, and then...
    • Crooks1130
      I’ve done multiple cam swaps with A/C installed and with it completely taken out. It’s soooo much nicer have it out of the way. My...
    • Crooks1130
      Crooks1130 replied to the thread Heads.
      Another way to tell is the bolt holes at the exhaust ports. 3 are in the same position and the 4th is the opposite. The one that is...
    • Crooks1130
      What RPM is it at when it does? Although mine is a “high performance” build, it does this same thing if I let it set for a while and the...
  • Loading…
  • Loading…
Top