Recent content by crzetex

  1. C

    Engine ICON came on in Dash

    This is funny! I have an 18 Lonestar and my truck did this exact thing yesterday. I have 3600 miles on it. I went out yesterday AM and started the truck and the CEL was on. I turned off the truck and restarted it and the light was still on. Went out after work and the light was off. Very...
  2. C

    Dead Speaker!

    Well I got it to work! I took the HU out for a minute or two the reinstalled it. When I turned it back on the speaker was working.
  3. C

    Dead Speaker!

    Greeting all! I have a 2018 Lonestar with the 8.4 UAS and base 6 speaker system. Today I started replacing the back door speakers with 6.5" coaxial. I did not use adapters for the speaker lines, and did splice into the factor wires. I check for polarity and wired up the new speaker leads...
  4. C

    Backup Cam. Use DD Reverse wire or Trailer Harness

    I tapped into the big trailer plug. The center wire was White with a red stripe.
  5. C

    2012 Crew cab install

    Well I worked on the doors some today and they are much better. Also did some tuning this weekend. I am very disappointed with the Planet Audio amp. Using a DMM and the math I am only putting out 75 to 80 watts per channel to my sub. I did change it over and I am now running it Bridged at...
  6. C

    2012 Crew cab install

    I plan on working on them this weekend. have some of he roof material in there already, what I could reach from the speaker hole and access on the other side. I think I'm gonna try to take the inner door panel out to access the door skin.
  7. C

    2012 Crew cab install

    Well thanks for your write ups. Your fiberglass write up was the info that put me in for trying the fiberglass. I had never messed with fiberglass before. It also gave me the information to start the deading process.
  8. C

    Sound System Install Questions (Noob Alert)

    Running the door speaker wire was not as bad as it seems. Once you take the rubber boot off the connector assembly on the cab side you will see a white plastic piece that holds two connectors (two on driver side, one on pass.). There are two tabs on the top and bottom that release this...
  9. C

    2012 Crew cab install

    "I am just curious... did you have trouble with the diy sound deadening? or did it not quiet the cab enough?" I have not had an issue with it. I used the roof material on the back wall and front doors and then painted with the elastomer paint. Later I found some butyl rubber peel and stick...
  10. C

    2012 Crew cab install

    I used liquid nails and just glued MDF strips to the back wall and then velcro the amp board to the strips.
  11. C

    2012 Crew cab install

    Amp installed and box covered.
  12. C

    2012 Crew cab install

    Glassed enclosure and components.
  13. C

    2012 Crew cab install

    So, after a bit of lurking I decided that I was ready to add some upgraded sound to my Ram. I am currently running RES head unit (base speakers) with Planet Audio 4ch amp. Front components are Focal R-165S2 on channel 1 and 2, and channel 3 and 4 to a Alpine SWS-12D4. Fiberglass enclosure...
Top