Recent content by DERJ
-
-
-
Long tubes with cats
What brand LTs did you go with? I have ARH LTs with cats and can run without a tune and not get any errors. (I have a custom tune, but I remove it anytime I go to the dealer...) But mine may be unusual as I’ve heard others could not.- DERJ
- Post #12
- Forum: Engine & Performance
-
SOLD: 2014 Ram R/T OEM seat covers
Sure and IM me if you have any other questions About them. -
SOLD: 2014 Ram R/T OEM seat covers
No stain, just wet from where my rag with leather cleaner touched them (I was cleaning the new covers at the time the pic was taken.) I ordered the new covers from https://www.shopsar.com/dodge-ram-accessories-s/2254.htm -
SOLD: 2014 Ram R/T OEM seat covers
Yes, those look almost identical to mine. Here are a few pics of mine when I actually swapped them from my seats: -
-
SOLD: 2014 Ram R/T OEM seat covers
Selling a set of OEM premium cloth high back bucket seat covers from my 2014 Ram 1500 R/T. These are in excellent shape (no stains, tears, spills, bodily fluids, etc...) and were only used for around 9 months (upgraded to Katzkin) and have been stored away ever since. Don't have exact part... -
-
FS: INEZ (IHC) 4" front lowering control arms (4th Gen 2WD) w/ upgraded Mevotech ball joints
The springs are still available (control arms are long gone...) -
Gen 4 garage sale- flaps, mats, tips, and spats
PM sent on the mud flaps... -
Black Sport Grille
I had the R/T honeycomb grill, but switched out the inserts from a Sport last Dec. When I did, I removed the chrome portions and had them painted white to match: -
Programming after new steering rack (EPS)
Guys, any way to program / code in a new steering rack without having to go to the dealer? The EPS went out in my 2014 and I replaced the steering rack myself, but I’m read there’s some scan code that needs to be read and programmed from the new rack - is anyone familiar with what this is and...- DERJ
- Thread
- Replies: 4
- Forum: 4th Gen DIY
-
Crown Suspension 3" Front Drop Springs RCSB R/T
I had Belltech springs in before, but ended up cutting too much, which is why I swapped to the Crown springs (just happen to still have them from a prior experiment. No, I only needed to cut about a 1/4” on pass side to get them even. The additional 1/2” cut what to get them lower.
