Recent content by EagleChief

  1. EagleChief

    Rear right wheel bent

    Both of your own responses will answer the question as to why it looks like that. Did you buy the truck used? Run a CarFax report on it, or did you own the truck when hit? Whoever did the repairs apparently didn't do a very good job of matching stuff up. That's my amateur thoughts anyway.
  2. EagleChief

    Where is the Headlight Adjustment on a 2013 Ram 1500 Tradesman ?

    Top of the fender, behind each light. There are a couple of holes with arrows pointing to them. Those are your adjustment points.
  3. EagleChief

    Headlight conversion

    Not to my knowledge. Curious why you want to switch them out for the halogen headlights? They are typically viewed as an inferior set to what you currently have. Most people are trying to get the projector headlights for better light output.
  4. EagleChief

    Best Mods for Under $100

    Yea, absolutely. The piping has a flat portion that is intended to be sewn into fabric. You just push that flap into the seam of where you want it placed. Typically in between panels where you can wedge it in. It used to be called the 25 cent mod. Pretty sure there are a lot of pics and videos...
  5. EagleChief

    Best Mods for Under $100

    I have it on my truck as well. Ordered it off of Ebay. Just look for vinyl seat piping. It'll go anywhere you can imagine, or want it to go. Here's some on Amazon...
  6. EagleChief

    I'm not happy with Method Rims

    You might check in the "Lifted" sub-forum to see what others have done/used, if you haven't already. I would think there's probably a lot of info with this same or similar scenario.
  7. EagleChief

    Best Mods for Under $100

    Update to these knob covers. Although they look pretty good and fit the knobs well, there's not a good way to keep them on the knobs. They kept falling off with use, as they just slip over the stock knob. I got tired of picking them up off the floor, so I ended up leaving them off. It was mainly...
  8. EagleChief

    Leaking Cab

    I know you said you replaced the 3rd brake light, but did you replace the gasket that goes around it. That is the culprit of the leaking, typically, not the light housing itself. You might try that.
  9. EagleChief

    Passenger storage area mat

    You could always find an upper glove box at a salvage and replace the opening with that. Lots of folks have done it on here.
  10. EagleChief

    Hanging air dam

    You can take it off. Some have done it, just to get more ground clearance up front. I trimmed the bottom portion of mine off (the flat downward piece) just for the sake of doing it. Made the front end look a little higher. It is mainly there for fuel mileage.
  11. EagleChief

    fix for non existant spray on windshield ?

    This happened to me. Mine had quit working. Finally got around to looking this weekend and the nozzles had snapped off in the hose fitting. Cleaned it out with a small screwdriver and put my new nozzle sprayers in. I only pulled 3 of the retainer tabs out and get to the hoses. I had the trim...
  12. EagleChief

    Leaking third brake light 2016

    I replaced mine (2014) after reading about it on here, not long after I bought the truck. Well, after about 9 years, I had to replace the gasket again. I had a leak this past fall with my replacement gasket. Went and pulled the package of that I used 9 years ago, applied a new seal around the...
  13. EagleChief

    Second thoughts on fender flares..

    I've always liked the smooth flares, as well. To me, it's a much cleaner/stylish look. Also, these type of flares fit up well with the chrome bumpers, which I have. I've had these saved for quite a while. I just don't want to spend the money to have them painted to match...
  14. EagleChief

    Bra Confusion

    At least I'm not the only one... I was a tit bit disappointed when I started reading. :p
  15. EagleChief

    Good dealer to buy from (anywhere in US)?

    I'm not sure how they are as of late, but there was a place in Idaho named Dennis Dillon that used to sell a lot of 2500's all over the country. I remember reading a lot of members on here buying from them. I have no personal experience, just second hand from reading on here.
See more

Latest posts

Members online

... and 27 more.
Total: 1,330 (members: 77, guests: 1,253)
Robots: 1,745

Forum statistics

Threads
195,462
Posts
2,870,553
Members
156,171
Latest member
Cajunnole

Share this page

Top