My trans decided to go out and I’m looking for a replacement, what are the differences between these and the Durango 5.9 transmissions? I have a 1998 ram 1500 5.2 chassis auto with a 5.9 swap. I’ve heard that there are differences depending on the years, is this true?
Sent from my iPhone using...
I’ll hopefully be fixing it next week, parts are on the way! As a bit of a newbie to transmission work, is RTV okay for the pan gasket?
Sent from my iPhone using Tapatalk
I checked the fluid on the side of the road and it was full, but it did smell burnt. The linkage I will need to check. But it didn’t feel any differently than usual.
Sent from my iPhone using Tapatalk
I think my transmission just went out on me. It doesn’t shift out of first gear and then it starts to slip. Am I crazy?
Sent from my iPhone using Tapatalk
I was on my way home and my radio shut off, then I heard a pop and started smelling a burnt smell and smoke. I pulled my radio and saw some wires had melter together (not sure how) I fixed those and replaced the fuse but when I turned it on there was smoke from behind the gauges and the fuse...
So I tried bleeding the system and found that only the top 3 inches of the radiator get hot. I assume that’s a clog of some kind?
Sent from my iPhone using Tapatalk
I’ve got a 98 1500 which has had a 99 5.9 swapped in (still running in the 5.2 computer) that has just started overheating. I just did a water pump when I put the engine in less than 1500 miles ago. Pretty much whenever I drive I need to have the heater on full blast and the engine temp will...
I believe the plenum was already done when I purchased the engine. And I have already done distributor wires and plugs. So heads and tune? Then exhaust? I can do that at home as my father has a welder and loads of experience. What heads did you buy/where did you get them? Also thanks for all the...
I've got a 98 ram with a 99 5.9 engine and I'd like to do a bit of a build, first heads (engine quest) then carb conversion and eventually a cam. I know for the carb conversion I need to get a different intake, would it be worth it to get the heads with the older LA bolt pattern for more...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.