Recent content by Gmantwo

  1. G

    Hemi tick

    Yes, we do
  2. G

    What is the correct 8HP70 fluid capacity when dropping pan?

    I used LiqiMolly
  3. G

    Transmission pan and fluid change questions

    Yep, I was talking about getting the pan swapped out. Not enough clearance because of the exhaust crossover
  4. G

    PPE pan 8HP75

    Y’all should warn somebody that when it over fills and runs out the drain hole, it’s going to run right into the hot exhaust and then right onto your arm!
  5. G

    PPE pan 8HP75

    After going through the green sheet fill process I got 5-1/2 quarts in
  6. G

    PPE pan 8HP75

    Poured it into jugs and it’s just over a gallon. Doesn’t count the small amount I lost putty in Caulks part. We’ll see after I run it & refill
  7. G

    PPE pan 8HP75

    Poured it into jugs and it’s just over a gallon. Doesn’t count the small amount I lost putty in Caulks part. We’ll see after I run it & refill
  8. G

    PPE pan 8HP75

    Only able to get a couple more ounces in
  9. G

    What is the correct 8HP70 fluid capacity when dropping pan?

    Just checked. Only able to get a couple ounces in before it ran out
  10. G

    What is the correct 8HP70 fluid capacity when dropping pan?

    Just did my pan last night. Took just over 3 quarts to run out the plug. Left it overnight and I’m about to see if it’ll take any more. Figure maybe the filter has soaked up some. And yes, I followed the instructions to a tee my back is still jacked up and the rails are level.
  11. G

    PPE pan 8HP75

  12. G

    PPE pan 8HP75

    Yes, it’s still jacked up
  13. G

    PPE pan 8HP75

    They’re wrong, lol
  14. G

    PPE Pan Install Issue

    When I tried the rear trans mount relief, the engine, and the exhaust, just went up with it. Didn’t help at all
  15. G

    PPE pan 8HP75

    I use nothing but Kroil to break stuff loose, best there is. I loosened the cats from the manifold
See more

Latest posts

Staff online

Members online

... and 20 more.
Total: 1,606 (members: 70, guests: 1,536)
Robots: 1,662

Forum statistics

Threads
195,606
Posts
2,872,453
Members
156,421
Latest member
WVPOWERMAN

Share this page

Top