So I got the check fuel cap message a week ago, then the CEL for it. I put in a new cap and cleared codes. Less than 100 miles later I get just the CEL with no check gas cap light. Codes are for gas cap, small evap leak and large evap leak (p0456). I'm going to change out the purge valve but...
Just did this today and I'll tell you what. It's a lot harder than the video's make it look. LOL
The top screw was so freaking tight, what a PIA to get that loose, especially with how tight it is to get up there. Then the bottom line was bent in a way that didn't let the nut push back after it...
There's a whole bunch of reasons that could happen. Bad cv axle, transmission shudder, tire balance is off, etc... I would have a shop troubleshoot the issue for you.
The brake controller will not work unless you enable it with Alpha or have the dealer flash the code. The module is a giant pain in the ass to install FYI.
The dry weight they tell you online doesn't account for propane, WDH or anything you put in the camper. Sounds like you're cutting it...
They should sell it as a kit and you can install it yourself.
Like chri5k said, hit up @AllMoparParts.com and Benny should be able to get you the part number for the kit for your truck.
You have to push them up by hand. The mirror goes from horizontal to vertical. The power fold means the entire assembly folds inwards towards the door.
This happened to my 2018 3500 6.4l. Would go into limp mode with no codes while towing my camper. CE light eventually came on though. It was the valve body. Got that changed out under warranty and no problems since.
Those are the procedures I followed except not doing a last manual bleed on the right side. I have more fluid so I'll do another manual bleed tomorrow I suppose to make sure all the air is out.
Thanks for the info.
Yesterday I switched out the HCU for ABS system on my 2018 3500 6.4l. I did the initial bleed then ran the ABS bleed in Alpha. I expected to have to open all 4 valves but it only did the passenger front and rear. I did it twice to make sure I didn't screw it up but started on front right then...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.