Recent content by Greylord

  1. G

    Rear Differential Yoke Bolt Torque Specs When Replacing Pinion Seal

    Rear pinion flange bolts, 85 ft lbs (a lot more than I would think) info from Mitchell on demand
  2. G

    Front Wheel Bearings

    If its a serviceable wheel bearing (example 2wd front) make sure they're installed correctly and with the proper preload. Pack them according either with your palm or grease Packer. Tighten the nut while rotating the hub more than snug, back off nut until minimal palsy is found than tighten to...
  3. G

    ABS Wiring

    That's normal for your unit. It has "3 wheel abs", works as 4, but only had 2 sensors (left front and rear axle)
  4. G

    Rear ABS

    Depending on 3rd of 4th gen. The pickup may have 2 wheel (on rear axle housing) 3 wheel (axle housing/ left front wheel bearing) or 4 wheel (axle housing, left/right front wheel bearings)
  5. G

    Replacing the rear pinion seal (Help needed)

    Try a large socket (just big enough for the outside edge of the circumference. Or a soft punch/ wooden rod and a hammer. lightly work your way around. Don't forget to add grease to the garder spring before hand.
  6. G

    Rear Differential Yoke Bolt Torque Specs When Replacing Pinion Seal

    Hope this helps
See more

Latest posts

Staff online

Members online

... and 13 more.
Total: 1,345 (members: 63, guests: 1,282)
Robots: 1,777

Forum statistics

Threads
195,478
Posts
2,870,795
Members
156,196
Latest member
jackjudy3

Share this page

Top