Recent content by Josh22855
-
What is this and why is it unplugged?
That is a ground, plug it in.- Josh22855
- Post #6
- Forum: Engine & Performance
-
6.4L threaded oil port, Why 2?
I am curious as to why this 6.4 block has 2 threaded ports, I know a temp. sensor goes into the bottom port. What is the top port for? Simply plug it?- Josh22855
- Thread
- Replies: 0
- Forum: Engine & Performance
-
Where Can I find SOLID engine mounts?
Yeah I did run across many hemi block solid mounts but nothing specific to the ram 1500. I am sure it will have to be custom.- Josh22855
- Post #13
- Forum: Engine & Performance
-
Where Can I find SOLID engine mounts?
Yeah I seen that blue truck run when it was N/A, now with that 422 Whipple combo it is going to be deep 9's/ high 8's quarter mile.- Josh22855
- Post #12
- Forum: Engine & Performance
-
Where Can I find SOLID engine mounts?
Matt still has/had stock, is Rick the man with the Blue ram?- Josh22855
- Post #10
- Forum: Engine & Performance
-
Where Can I find SOLID engine mounts?
Thanks again, I got a hold of a 6.4 that is about to grow in size! I do not believe the stock mounts will be sufficient for what's soon to come.- Josh22855
- Post #7
- Forum: Engine & Performance
-
Where Can I find SOLID engine mounts?
No, this is the first that I have heard of them, I will definitely reach out to them. I appreciate it!- Josh22855
- Post #5
- Forum: Engine & Performance
-
Where Can I find SOLID engine mounts?
Thanks for the info, I may go this route and also fab up something to keep the block solid to the frame.. I lost a transmission and block a few months back at the track and sadly I am still uncertain the cause of it.- Josh22855
- Post #3
- Forum: Engine & Performance
-
Where Can I find SOLID engine mounts?
Does anyone know where I can find a set of Solid engine mounts for a 2016 Ram 1500 single cab? I have searched and searched with no luck. I do not have a Facebook so I am unable to poke around on the high performance ram page. Any info is appreciated. Thanks.- Josh22855
- Thread
- Replies: 14
- Forum: Engine & Performance
-
Another destroyed transmission....
I found out that these aftermarket stroker cranks require a $20 pilot sleeve for the torque converter. I am hoping this was the cause of the transmission destruction. Here are a few pictures of the destruction, viewer discretion advised .- Josh22855
- Post #60
- Forum: Engine & Performance
-
Another destroyed transmission....
Little video of the damage. https://youtu.be/OxC5ewVC-Xg- Josh22855
- Post #55
- Forum: Engine & Performance
-
Another destroyed transmission....
I did a search for them but cannot seem to find anything like that.- Josh22855
- Post #46
- Forum: Engine & Performance
-
Another destroyed transmission....
I had some severe vibrations with a previous driveshaft so I had one made and it was a night and day difference. I am now convinced that the engine needs better mounts/chain.- Josh22855
- Post #44
- Forum: Engine & Performance
-
Another destroyed transmission....
That profile picture was with a 1st gear leave with a built 8HP70, that was the last time that I have left the line from 1st gear. Now I launch from 2nd gear and front end stays on the ground. Does anyone offer any more suitable motor mounts for my application? Also where could I find that...- Josh22855
- Post #39
- Forum: Engine & Performance
-
Another destroyed transmission....
Yeah I will have to do something similar to this, I'd like some type of support under the bell housing as well.- Josh22855
- Post #26
- Forum: Engine & Performance
