-
-
KKrmcfarlin replied to the thread 4.7 Crank No Start Help Please? (SOLVED).Update, truck is fixed. After replacing the Cam Position Sensor and it not helping I decided to test compression. When plugging the...
-
KI have a 2006 4.7. The other day I noticed at start up my truck would idle a little rough, smoke a little bit but after a second or two...
-
KKrmcfarlin replied to the thread Camshaft position sensor.What did you ever come up with on your truck? I’m currently experiencing a similar issue.
-
KKrmcfarlin replied to the thread Front Turn Signal not working Please Help!.I’ll run it down and see what’s up with it.
-
KKrmcfarlin reacted to chopperman1's post in the thread Front Turn Signal not working Please Help! with
Like.
Check the ground to the light (the 3rd pin), it's probably open (ie broken wire somewhere). -
KToday I went to fix my front driver side turn signal. (Rear is fine) This is what I’ve found so far: 1. Bulb is fine, even put a new...
-
KKrmcfarlin replied to the thread SOLVED: High Idle and Loud Hissing Noise.You were correct. I went to the junk yard and got an EGR tube. The 4.7s don’t have mounting brackets. The tube I had was bent just...
-
KKrmcfarlin replied to the thread SOLVED: High Idle and Loud Hissing Noise.Does any one have a picture of the EGR mounting bracket marked “1”? I can’t find one online send most pictures block it with the sensors...
-
-
KKrmcfarlin replied to the thread SOLVED: High Idle and Loud Hissing Noise.So I believe I have found the issue. The EGR tube that goes from the Egr valve to the intake is leaking at the intake. I can see the...
-
KKrmcfarlin replied to the thread SOLVED: High Idle and Loud Hissing Noise.@Travelin Ram ill give this a shot, do you think that would have anything to do with the CEL as well? It threw a code for low fluid but...
-
KKrmcfarlin replied to the thread SOLVED: High Idle and Loud Hissing Noise.@pacofortacos ill go check them out again, I appreciate the response. Apart from the lines that run to the Purge Valve solenoid under...
-
KI recently picked up a 2006 Ram 4.7 that sat for a few months so I’m getting it back on the road. My only issue with the truck is that...
-
-
Loading…
-
Loading…
Members online
- Scully311
- RamDiver
- Xman19DS
- RC Turner
- Dredger
- Harry O
- KalboKalbs
- MurphyEF
- Dark Knight 500
- CRS1968
- BADHEMI1
- Team Horner
- 14 Lonestar
- pboulianne35
- ColesRAM
- Brandon-w
- tjfdesmo
- Ramjay
- Moparman16
- Lsujker
- Hill834
- Travelin Ram
- Rollertoaster
- Brads41789
- thefiremon
- tbronga
- bigcrew
- BDay2351
- Jefferson Davis
- Christopherrlegau
- Jeepwalker
- 6speed4.7
- Smitty082261
- cityredneck
- 1500Rammer
- TestPilot57
- jawzs2
- Lyle Longboat
- ER2531
- emjohn4
- Jpage978
- smoothee
- trajan3
- Colombo_Bru
- Wild one
- FreeRange
- quickster2
- TonyT4
- indept
- Ole Buck