I had no issues with my fahrens until we started seeing below 0 weather. They started to get a slight flicker and it was getting worse as the temps dropped.
Sent from my SM-G988W using Tapatalk
Okay, so I went out and ran logs again - Not showing showing wait to start present, still. I think it disabled since I don't have a diesel.
The codes it was throwing was Passive 1 & 2 - I didn't do passive entry, so I am assuming that's why.
I'll attach a comparison of my logs.
Remote Start is...
Drove about 10 mins, that fixed my tire sensors. Did 2 resets, another about 2hours later with no success. So I enabled wait to start - and it worked for my remote start. I ran a log 10 mins ago and it looks like it turned itself off ?
Hmm. Looks like my back up cam is back too, maybe tomorrow...
Do you think I need "“vehicle configuration 5 wait to start”" to use my OEM remote start? It wasn't working until I made this change. Maybe it's on a delay as well?
Hey guys - Just finished the mod but having some issues.
my remote start isn't working (factory)it starts the blowers but engine doesn't run , Sirius XM disappeared and back up cam is now gone and doesn't show my passengers heated seats , it appears to have changed my unconnect ? I don't even...
Just to confirm this is all I need from Mopar. I am not doing door handles as the price skyrockets in the land of Canada.
68319680AE Hub Receiver
56046958AA Passive Entry Antenna x 2
6CK46DX9AC Ignition Switch
I appreciate you sending those pics! I went and pulled back 16" of tape, no breaks and I don't have a blue/pink wire. I'm wondering if it was just loose in the harness, taped in there and not needed. I'll just leave it for now, lol.
I recently did the console swap, went to reuse my wiring harness from my classic to retain the media hub and when I was looking at it this wire seemed very loose and it fell out of the harness.
Does anyone know where it goes ? I pulled back some tape and couldn't figure out where it tied into...
I've got a 2019 classic with the 8.4 non NAV Uconnect. I'm swapping my jump seat to a console from a 2013, what's required for my android auto / car play to work hub wise? Can I use my existing jump seat hub?
Sent from my SM-G988W using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.