Yup just the cover. The switch I did was from an 07 1500 to an 06 3500
The newer smaller rig had a different mounting plate than the CTD:
06 3500's mounting plate:
Brackets come off w/ a couple bolts and the cover can be swapped:
Back bumper lines up just fine.
Sorry it wasn't a fully...
Get the stock OEM cab lights. The seal used in the OEM is the best you'll get. But you can't buy them by themselves. You have to buy the entire kit.
Either night shade the amber or get the lenses from someone else.
The seals for Recon have gone to poo over the last few years. More and...
On our's the resonator was near the tip so it was able to be left in w/o issues. Looking at it it looked almost exactly like an Aero resonator.
Good luck finding a combo you like :)
They have the 4.7 Ram listed. The 4.7 in the Ram and the Dak are exactly the same. Same trans too. It is just slapped in a different body.
Have spoken w/ several Dodge & after market folks all say that if it'll work in the 4.7 Ram it'll work in the 4.7 Dak.
Guess I just need to call them...
With our 4.7 '09 Dak there were two mufflers and a resonator stock.
We simply removed the lower muffler and left the 1st and resonator in the exhaust flow.
Sounds pretty nummy :)
Question on the Trinity:
Looking at getting one for the hub's 4.7 Dak at some point in the near future. Does it have any torque management control? The way his transmission shifts drives me INSANE. I know you can fiddle with the shift points and all. But it's the way it applies the power...
If you're using the stock pan and would like to stay a little clean ... you can use small flexible tubing down the fill tube and suction some out.
Most shops will have a pump system and draw the fluids out this way ... it wont hurt a thing.
Then the pan is low enough you can lower it...
See now knowing what you do for a profession I must rethink the first thought that came into my head with those plates :D
Any plans for the chrome bumpers? If your gonna add the black in there at the wheels / tint level (think that was on your to-do list from the other post) them'z gonna...
Recall 10v657000: Tie rod left ball stud
Vehicle Make: DODGE
Vehicle Model: RAM
Model Year(s): 2008-2011
Manufacturer: CHRYSLER GROUP LLC
Mfr's Report Date: DEC 23, 2010
NHTSA CAMPAIGN ID Number: 10V657000
NHTSA Action Number: N/A
Component: STEERING:LINKAGES:TIE ROD...
Check for codes (use the key and turn from off to run 3 times w/o starting ... they will show on the ODO even if the check engine light is not on). If the lift pump is going out you'll get a few different ones.
What did you replace it with? Stock or aftermarket?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.